Results 151 to 160 of about 19,472,085 (300)
Modeling and simulation of a MMC-based solid-state transformer
This paper presents a model of a bidirectional MV/LV solid-state transformer (SST) for distribution system studies. A modular multilevel converter configuration is used in the MV side of the STT.
Adabi Firouzjaee, Mohammad Ebrahim +2 more
core
Elastic–Plastic Modeling and Experimental Characterization of Granular Jamming Actuators
Granular jamming enables rapid switching between soft and rigid mechanical states. Here, a reduced‐order elastic‐perfectly‐plastic beam framework captures pressure‐dependent loading, unloading, residual deformation, and hysteresis in jammed beams, while matching three‐point bending experiments across materials and geometries. The framework links design
Saheli Patel +2 more
wiley +1 more source
Advanced Solid State Lasers 2015
ASSL highlights new sources, advanced technologies, components and system design to improve the operation and application of solid state lasers.
core +1 more source
Additive manufacturing introduces pronounced microstructural and crystallographic anisotropy in Ni‐based superalloys, resulting in orientation‐dependent creep deformation and damage. This review identifies the key microstructural origins of creep anisotropy, examines their influence on dominant deformation mechanisms, and highlights processing ...
Chandan Kumar +3 more
wiley +1 more source
A high voltage gain solid-state transformer for integration of renewable energy and AC sources. [PDF]
Hashemzadeh SM +6 more
europepmc +1 more source
Additively manufactured AlCrFe2Ni2 with contrasting BCC/B2‐dominant and lamellar FCC + BCC/B2 microstructures exhibits the same pressure‐induced BCC/B2 → HCP transformation. Under laser heating at high pressure, HCP is destabilized, and a cubic BCC/B2 + FCC assemblage is recovered, while the lower‐scan‐speed microstructure transforms at a lower ...
Raimundas Sereika +5 more
wiley +1 more source
Impact of Hydrogen Incorporation on Electronic and Magnetic Structure of X2CrNi18‐9 Stainless Steel
Hydrogen uptake in austenitic stainless steel alters both its electronic and magnetic structure. Seebeck measurements reveal hydrogen‐induced shifts in the electronic density of states, while neutron scattering uncovers nanoscale inhomogeneities that grow upon hydrogen incorporation, with the most pronounced effect observed in the PBF as‐built state ...
Torben Tappe +9 more
wiley +1 more source
Hybrid VAE-Transformer-based multi-task learning for cyberattack detection and fault classification in electric vehicle charging stations. [PDF]
Vinitha R, Senthil Kumar R.
europepmc +1 more source
Microstructural evolution of premium rail steel during flash butt welding (FBW), comparing physically simulated heat‐affected zones with actual weld regions. Thermal cycles induce phase transformations and microstructural heterogeneity that influence weld quality and mechanical performance. These findings provide insights into optimizing FBW parameters
Emmanoelle Cintra da Cunha Araújo +15 more
wiley +1 more source
Frequency-Dependent Surface-Discharge Lifetime and PRPD Failure Signatures of Polyimide Insulation Under High-Frequency Sinusoidal Voltage. [PDF]
Li B, Qi T, Li Q.
europepmc +1 more source

