Results 121 to 130 of about 1,379,495 (302)
Reducing the mechanical wear of elbows and pipes due to solid particles flow by using nano coating technique. [PDF]
Sci Rep, 2021 Al-Ithari AS, Al-Zurfi N, Kareem LZAUL.
europepmc +1 more source
Advanced Engineering Materials, EarlyView.Microstructural evolution and hardness optimization along the cross‐section of friction stir welded AA6061/AlSi10MgMn joints, for electric vehicle battery housings, were investigated. Postweld aging between 170°C and 220°C enhances hardness uniformity within the nugget zone.
Emanuele Ghio, Emanuela Cerri
wiley +1 more source
Rheology of Highly Concentrated Suspensions with a Bimodal Size Distribution of Solid Particles for Powder Injection Molding. [PDF]
Polymers (Basel), 2021 Mityukov AV +3 more
europepmc +1 more source
Moving particle simulation with solid-solid contact
, 2017 Problems of fluid-structure interaction with free surface flow and multi-body interactions are highly nonlinear and complex phenomena, which is challenging for computational modeling and simulation. In the presence of contact or collision between solids, numerical modeling to detect collision and prevent penetration between bodies is required.
Amaro Junior, Rubens A. +2 more
openaire +1 more source
Advanced Engineering Materials, EarlyView.Herein, environmental scanning electron microscopy (ESEM) is discussed as a powerful extension of conventional SEM for life sciences. By combining high‐resolution imaging with variable pressure and humidity, ESEM allows the analysis of untreated biological materials, supports in situ monitoring of hydration‐driven changes, and advances the functional ...
Jendrian Riedel +6 more
wiley +1 more source
Ice nucleation of water droplet containing solid particles under weak ultrasonic vibration. [PDF]
Ultrason Sonochem, 2021 Gai S +4 more
europepmc +1 more source
Advanced Engineering Materials, EarlyView.In this experimental study, the mechanical properties of additively manufactured Ti‐6Al‐4V lattice structures of different geometries are characterized using compression, four point bending and fatigue testing. While TPMS designs show superior fatigue resistance, SplitP and Honeycomb lattice structures combine high stiffness and strength. The resulting
Klaus Burkart +3 more
wiley +1 more source
Scattering by fluffy grains [PDF]
There are indications (Greenberg et al., 1988), that fluffy (i.e., porous) particles are responsible for the observed 3.4 and 10 micron emissions of comet Halley. The absorption characteristics of small particles both solid and fluffy are needed in order
Greenberg, J. Mayo, Hage, J. I.
core +1 more source
Advanced Engineering Materials, EarlyView.This study investigates laser metal deposition of aluminum alloys EN AW‐7075 and EN AW‐5083, using powder blending to compensate zinc and magnesium evaporation. In situ alloying and ex situ alloying with ZnAl12 and AZ91 preserve near‐standard compositions and improve mechanical properties.
Finn Bendixen +3 more
wiley +1 more source
Rheocasting versus Die Casting: An Insight into the Low‐Cycle Fatigue Behavior of AlSi7Mg0.6
Advanced Engineering Materials, EarlyView.The study compares rheocast lightweight components with high‐pressure die cast materials regarding microstructure and fatigue behavior. Rheocast process offers higher efficiency due to lower casting temperatures. Despite some microstructural differences, both processes show similar strengths (yield strength 125 MPa, tensile strength 240 MPa).
Julia Richter +4 more
wiley +1 more source