Results 41 to 50 of about 440 (156)
Optimisation of Torque Ripples in Permanent Magnet Synchronous Motor using Hysteresis Current Controller [PDF]
This paper’s primary goal is to investigate and analyze how a particular PWM technique enhances the performance of PMSM drives. The objective of the analysis is to reduce torque ripples, which are fluctuations or variations in the motor’s torque output ...
Pala Prasad Reddy Mule +4 more
doaj +1 more source
This paper proposes a modelling method based on multi‐software co‐simulation to precisely model radiated interference in permanent magnet servo drive systems. The accuracy of the simulation model is validated through comparison with actual measurement results. ABSTRACT High‐frequency switching operations of power switching tubes generate high‐frequency
Jingxuan He +7 more
wiley +1 more source
Power Converter's IGBT Multi‐State Reliability Analysis for Low Failure Rate Operation
This paper proposes a multi‐state reliability analysis for IGBTs in power converters, moving beyond the conventional two‐stage model with a constant failure rate and introduces a multi‐state Markov chain model for voltage source converters under different modulation scenarios.
Qiaohan Su +3 more
wiley +1 more source
Position Control of BLDC Motor with Space Vector PWM Method
In order to improve the performance of Brushless Direct Current (BLDC) Motor, Space Vector Pulse Width Modulation (SVPWM) based controller technique is applied in this paper.
Süleyman KOKUNDU, M. Timur AYDEMİR
doaj +1 more source
Simplified implementation of 3L-SVPWM algorithm and neutral-point balancing
The traditional implementation method of the three-level space vector pulse width modulation (3L-SVPWM) needs multiple region judgment and a lot of trigonometric function operation, which has a large amount of calculation and increases the burden of the ...
Zhenshang Wang +6 more
doaj +1 more source
In this paper, a novel method based on space vector pulse width modulation (SVPWM) for a five‐phase voltage source inverter is presented, which uses a proposed sampling time sharing (STS) technique to provide independent control of the fundamental component and the third harmonic.
Danyal Ghasemi +3 more
wiley +1 more source
In this paper, in order to effectively reduce the electromagnetic noise of automotive electronic water pumps, a Hybrid Random Carrier Space Vector Pulse Width Modulation Hybrid Random Carrier Space Vector Pulse Width Modulation, (HRCSVPWM) technique ...
Xiaodan Feng +3 more
doaj +1 more source
Novel Approach for Power Management‐Based NPC STATCOM for Grid‐Connected Photovoltaic Battery System
ABSTRACT The development of power quality control systems and methods is a credible step for the modernization of the power grid. In this context, this paper presents novel approaches for the control of power quality and voltage of the power grid using power converters connected to photovoltaic battery systems.
Kamel Sayahi +3 more
wiley +1 more source
To address the harmonic issues associated with the pulse width modulation (PWM) method, this article introduces variable delayed time (VDT) space vector pulse width modulation (SVPWM) with double central symmetry for dual three-phase permanent magnet ...
Tao Tao, Sen Liu
doaj +1 more source
STEP1:Analyze the differential characteristics of four IGBT open‐circuit faults in the H‐bridge module. STEP2:Analyze the impact of different IGBT faults on PWM voltage within a switching cycle. STEP3:Establish a hierarchical and collaborative fault‐tolerant control system: The zero‐mode control strategy dynamically switches modes according to the ...
Lei Dong +6 more
wiley +1 more source

