Results 131 to 140 of about 61,567 (256)

Safety of Prescription Nonsteroidal Anti‐inflammatory Drugs in Adults with Inflammatory Bowel Disease: Data from a Large Administrative Claims Cohort

Arthritis Care &Research, Accepted Article.
Objectives The concern that nonsteroidal anti‐inflammatory drugs (NSAIDs) may precipitate flares of inflammatory bowel disease (IBD) has limited their use in managing musculoskeletal symptoms in this population, but safety data are mixed. Methods This retrospective cohort study included patients with IBD ≥ 18 years of age from Optum's de‐identified ...
Adam S. Mayer, Rui Xiao, Meenakshi Bewtra, Michael D. George, Pamela F. Weiss   +4 more
wiley   +1 more source

Real‐world trends in prenatal antirheumatic drug utilization in Ontario, Canada: A cross‐sectional time‐series analysis

Arthritis Care &Research, Accepted Article.
Objectives This study aimed to describe real‐world trends in preconception and prenatal use of antirheumatic drugs among pregnant individuals with rheumatic diseases in Ontario, Canada. Methods We conducted a time‐series analysis using repeated cross‐sectional data to examine annual patterns of disease‐modifying antirheumatic drug (DMARD) use among ...
Shenthuraan Tharmarajah, Swaleh Hussain, Sara J.T. Guilcher, Lisa M. McCarthy, Dharini Mahendira, Howard Berger, Mina Tadrous   +6 more
wiley   +1 more source

β‐Catenin/c‐Myc Axis Modulates Autophagy Response to Different Ammonia Concentrations

Advanced Biology, Volume 9, Issue 3, March 2025.
Ammonia, detoxified by the liver into urea and glutamine, impacts autophagy differently at varying levels. Low ammonia activates autophagy via c‐Myc and β‐catenin, while high levels suppress it. Using Huh7 cells and Spf‐ash mice, c‐Myc's role in cytoprotective autophagy is revealed, offering insights into hyperammonemia and potential therapeutic ...
S. Sergio, B. Spedicato, G. Corallo, A. Inguscio, M. Greco, D. Musarò, D. Vergara, A. F. Muro, G. De Sabbata, L. R. Soria, N. Brunetti Pierri, M. Maffia   +11 more
wiley   +1 more source

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

Advanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti, Finn‐Lennard Janthur, Selina Raumel, Sascha Jan Zimmermann, Sarah Seffer, René Gustus, Sebastian Herbst, Marc C. Wurz, Ludger Overmeyer, Wolfgang Maus‐Friedrichs, Hans Jürgen Maier, Florian Nürnberger   +11 more
wiley   +1 more source

Tribological Performance of 60NiTi Alloy Under Varying Contact Conditions and Elevated Temperatures in Linear Reciprocating Sliding

Advanced Engineering Materials, EarlyView.
This study investigates the tribological response of 60NiTi alloy under dry, water‐lubricated and high‐temperature conditions. The alloy exhibits decreasing wear volume and friction with increasing temperature due to the formation of protective oxide layers. The work clarifies dominant wear mechanisms and demonstrates the suitability of 60NiTi for high‐
Anthony Onyebuchi Okoani, Miguel Angel Selles, Maziar Ramezani   +2 more
wiley   +1 more source

Influence of Voltage Variation on Plasma Parameters in Cylindrical Electrostatic Precipitators Using Optical Emission Spectroscopy

Ibn Al-Haitham Journal for Pure and Applied Sciences
In this work, plasma spectroscopy was used to measure the plasma parameters of a negative spark discharge in a cylindrical electrostatic precipitator (ESP) from spectral data (electron density ne, electron temperature Te, plasma frequency, and Debye ...
Hadeer Adil Abbas, Qussay Adnan Abbas
doaj   +1 more source

Characterization of Nitinol Produced by Laser Powder Bed Fusion for Mechanical Metamaterial Applications

Advanced Engineering Materials, EarlyView.
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek, Jakub Hurník, Miroslav Šmíd, Ondřej Zobač, Melanie Todt, Daniel Koutný   +5 more
wiley   +1 more source

Reduction of Oxide Inclusions During the High‐Frequency Welding of Steel via a Nonthermal Ar/H2 Plasma Jet

Advanced Engineering Materials, EarlyView.
High‐frequency (HF) welding of steel is limited by oxide inclusions that degrade weld quality. This study demonstrates, for the first time, the integration of a nonthermal Ar/H2 dielectric barrier discharge (DBD) plasma jet into HF welding. Local plasma treatment provides effective shielding and in‐situ oxide reduction, resulting in markedly fewer and ...
Viktor Udachin, Lienhard Wegewitz, René Gustus, Henning Wiche, Wolfgang Maus‐Friedrichs   +4 more
wiley   +1 more source

Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres

Advanced Engineering Materials, EarlyView.
This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann, René Gustus, Lienhard Wegewitz, Wolfgang Maus‐Friedrichs   +3 more
wiley   +1 more source

Calculation and experimental determination of the speed of advancement of the plasma leader channel of a pulse spark discharge in atmospheric air

Electrical engineering & Electromechanics
Goal. Calculation and experimental determination of middle speed vL of advancement of plasma leader channel of a pulse spark discharge in the long air interval of the double-electrode discharge system (DEDS) «tip-plane». Methodology.
M. I. Baranov
doaj   +1 more source