Modeling of the Specific Breakage Rate Based on the Viscosity for Wet Grinding
, 2017 A rheological modifier was used to prepare solutions with viscosities of 1, 4, 6 and 8 cp, which exhibited Newtonian behavior. These solutions were later used to prepare suspensions of monosize quartz (53, 45 and 38 microns) at 60 % in solids. Monosize grinding tests in a laboratory ball mill were performed to determine breakage parameters, with ...
Adriana Osorio +3 more
openaire +3 more sources
Estimation of ceramic material properties using specific rate of breakage determined from grinding tests of nepheline syenit [PDF]
, 2020 The author would like to acknowledge the TUBITAK for financially supporting this study (project name: TUBITAK-MAG-118M224).
Haner, Serhan
openaire +6 more sources
Powder Technology, 2013 Calculating specific discharge and breakage rates is an essential part of developing a grinding model for dry ball milling. With this purpose, detailed sampling surveys were performed to collect size distribution data at the steady state conditions of the cement grinding circuits at different plants.
Genc, O., Ergun, S. L., Benzer, A. H.
openaire +5 more sources
Dynamic response studies on aggregation and breakage dynamics of colloidal dispersions in stirred tanks [PDF]
, 2008 Aggregation and breakage of aggregates of fully destabilized polystyrene latex particles in turbulent flow was studied experimentally in both batch and continuous stirred tanks using small-angle static light scattering. It was found that the steady-state
Morbidelli, M. +16 more
core +4 more sources
Spherical Agglomeration: An Investigation of the Breakage Mechanism by Isolating the Breakage Rate Process [PDF]
, 2023 This thesis contributes to the field of spherical agglomeration by: • developing a simple model system to isolate the breakage process in the spherical agglomeration and investigate the effect of shear rate and bridging liquid viscosity on the breakage ...
Mohd Yusoff, Siti Norfarahin
core +4 more sources
Quantifying Particle Breakage and Its Evolution Using Breakage Indices and Grading Entropy Coordinates [PDF]
, 2022 Particle breakage in soils is a well-recognised behaviour. Conventional methods for quantifying the breakage process rely on calculating the area between the particle size distribution (PSD) curves produced before and after crushing.
Emőke Imre +7 more
core +1 more source
Revealing cracking and breakage behaviours of gibbsite particles [PDF]
, 2020 Mitigating gibbsite particle cracking and breakage during industrial alumina production can increase the quality of smelter grade alumina product by reducing the ultrafine particle content.
Ge, Lei +3 more
core +1 more source
The specific selection function effect on clinker grinding efficiency in a dry batch ball mill [PDF]
, 2008 Dry grinding experiments on cement clinker were carried out using a laboratory batch ball mill equipped with a torque measurement. The influence of the ball size distribution on the specific selection function can be approached by laboratory runs using ...
Frances, Christine +2 more
core +1 more source
Nanomaterials, 2022 To scale down semiconductor devices to a size less than the design rule of 10 nm, lithography using a carbon polymer hard-mask was applied, e.g., spin-on-carbon (SOC) film.
Jun-Myeong Lee +6 more
doaj +1 more source
A portable load cell for in-situ ore impact breakage testing [PDF]
, 2002 This paper discusses the design and characterisation of a short, and hence portable impact load cell for in-situ quantification of ore breakage properties under impact loading conditions.
Bourgeois, Florent +3 more
core +1 more source