Results 1 to 10 of about 96,443 (168)
Design optimization of cruciform specimens for biaxial fatigue loading [PDF]
Fracture and Structural Integrity, 2014 In order to correctly assess the biaxial fatigue material properties one must experimentally test different load conditions and stress levels. With the rise of new in-plane biaxial fatigue testing machines, using smaller and more efficient electrical ...
R. Baptista +5 more
doaj +6 more sources
Metals, 2022 Inconel 718 is a well-known nickel-based superalloy used for high-temperature applications. The aim of the present study was to formulate a constitutive equation (CE) that can be used to account for the deformation behavior of Inconel 718.
Jong-Soo Park +3 more
doaj +1 more source
Spline-based specimen shape optimization for robust material model calibration
Advanced Modeling and Simulation in Engineering Sciences, 2022 Identification from field measurements allows several parameters to be identified from a single test, provided that the measurements are sensitive enough to the parameters to be identified.
Morgane Chapelier +2 more
doaj +1 more source
Sensors, 2022 The identification of damage based on Lamb waves can hardly avoid obtaining the reference signal under healthy conditions. A non-reference damage localization (NRDL) method is proposed in this paper.
Yaogang Wu +4 more
doaj +1 more source
Desirability function based optimization of experimental data for air-water spray impingement cooling [PDF]
Management Science Letters, 2016 The current research copes with the optimization of the surface heat transfer coefficients of a square mild steel test specimen by spray impingement cooling.
Santosh Kumar Nayak +1 more
doaj +1 more source
Efficient optimization framework for L-PBF fatigue enhanced Ti6Al4V lattice component
Materials & Design, 2023 Industries today face challenges in incorporating metallic additively manufactured lattice structures in critical components subjected to fatigue loading.
Raffaele De Biasi +5 more
doaj +1 more source
Journal of Magnesium and Alloys, 2023 3D reconstruction and 2D observation were conducted to characterize the microstructure of the castings produced through high pressure die casting with different parameters.
Chaosheng Ma +5 more
doaj +1 more source
An optimized TEM specimen preparation method of quantum nanostructures [PDF]
Micron, 2021 20 pages, 6 figures, 1 ...
Hongguang Wang +5 more
openaire +3 more sources
STEM Imaging Optimized for Biological Specimen [PDF]
Microscopy and Microanalysis, 2005 Within STEM mode the signal of both the inelastic and elastic scattered electrons contribute to the contrast of the image. This is an advantage compared to zero-loss filtered TEM imaging, where a significant amount of electrons are not contributing to the image formation, especially in thicker samples, due to multiple scattering events.
B Freitag +5 more
openaire +1 more source
Optimization Design of a Small-Sized Cruciform Specimen for Biaxial Fatigue Testing
Metals, 2020 The in-plane biaxial specimen can well reflect the complex stress state of sheet metal. However, there is no standard for small-sized specimens used in the low-power biaxial fatigue testing machine.
Zheng Lu +3 more
doaj +1 more source