Results 181 to 190 of about 1,141,167 (296)
Optimized ITO back contact with pre‐Ga supply growth and Ag incorporation suppresses GaOx formation and interface recombination in bifacial CIGS solar cells. The devices achieve 17.25% front and 5.77% rear efficiency, delivering record bifacial power density up to 32.26 mW cm−2 in 4T perovskite/CIGS tandem architectures under enhanced albedo ...
Amanat Ali +13 more
wiley +1 more source
A dual‐functional evaporator based on CAU‐23/graphene hybrid is acquired through a modular design strategy. Owing to superior broadband light absorption, optimal wettability, and porous architecture that synergistically integrates nanoconfined ionic channels with photothermal conversion, it exhibits a high evaporation rate of 2.71 kg m−2 h−1 with the ...
Hangyuan Du +8 more
wiley +1 more source
Stabilization Strategies for Carbon Based Perovskite Solar Cells Under Light, Heat, and Humidity
Carbon‐based MA1−x(AVA)xPbI3/CsPbBr3 QD heterostructures fabricated under ambient conditions exhibit < 5% loss under ISOS‐D‐3 and reversible photo‐induced degradation, revealing the dual role of QDs in defect passivation and dynamic interfacial stabilization.
Emilie Planes +4 more
wiley +1 more source
Bias-programmable linear-to-nonlinear photoresponse for filter-free single-pixel VIS-NIR discrimination. [PDF]
Shin J +6 more
europepmc +1 more source
An S‐scheme red phosphorus/BiVO4 heterojunction is presented, where red phosphorus served as the water reduction site, and BiVO4 functioned as the water oxidation site. Because it has a built‐in electric field that helps charge transfer and separation, red phosphorus/BiVO4 works very well in the photocatalytic overall water splitting process.
Guanman Liu +9 more
wiley +1 more source
Variability of surface and underwater nocturnal spectral irradiance with the presence of clouds in urban and peri-urban wetlands. [PDF]
Secondi J +5 more
europepmc +1 more source
Polyelectrolytes represent a low‐cost and effective platform for tailoring charge extraction interfaces in inverted perovskite solar cells (PSCs). In this work, we introduce a protonated polyethyleneimine (PEI) layer (pH = 2) between the ITO electrode and the PTAA hole transport layer to increase the apparent work function of ITO by 0.066 eV and reduce
Aleksandra Furasova +10 more
wiley +1 more source
Spectral Optimization of Programmable LED Illumination for Smartphone-Based Colorimetric Biosensor Readout. [PDF]
Serea E, Donciu C, Temneanu MC.
europepmc +1 more source
Ni–Zn–Ga Alloy for Weak Sunlight‐Driven Methanol Production From CO2 and H2O at Ambient Pressure
The Ni–Zn–Ga ternary alloy‐assisted photothermal CO2 hydrogenation system coupled with photovoltaic water splitting could convert CO2 and H2O into methanol with a production rate of 709 μmol g−1 h−1 under natural sunlight irradiation. ABSTRACT The sunlight‐driven artificial photosynthesis that converts CO2 and H2O into methanol is a promising approach ...
Linjia Han +9 more
wiley +1 more source
Fluorescent Colored Passive Radiative Cooling Based on Carbon Dots for Cooling Power Recovery
We demonstrate colored passive radiative coolers consisting of a highly reflective porous ceramic base covered by an eco‐friendly luminescent carbon dot‐polymer composite, with two types of carbon dots enabling conversion of either ultraviolet or visible light, respectively.
Lin Liang +12 more
wiley +1 more source

