Results 51 to 60 of about 91,621 (266)

Advanced Electron Microscopy and Microcomputed Tomography Analysis of Single‐Crystal Ni‐Base Superalloys After Short‐Term Multiaxial Creep

open access: yesAdvanced Engineering Materials, EarlyView.
This work studies the anisotropic behavior of circular notched tensile specimens of Ni‐base superalloy single crystals during high‐temperature tensile creep along [001], [110], and [111]. Correlative scale‐bridging imaging of specimens reveals early rupture along [110] because 1) plastic deformation proceeds faster at notch center; 2) more (brittle ...
Leonardo Agudo Jácome   +6 more
wiley   +1 more source

The Gamma-ray Spectrometry of Fission Products, (V)

open access: yesJournal of the Atomic Energy Society of Japan / Atomic Energy Society of Japan, 1961
The calculation of scintillation spectra for the broad parallel gamma rays emitted from U235 fission products incident on a right circular cylindrical NaI (Tl) crystals is presented. Typical scintillation spectra from fission products are presented. The parameters of the spectra were tabulated as functions of time after fission.
openaire   +7 more sources

Influence of Scan Strategies in Electron Beam Powder Bed Fusion on Solidification, Microstructure, and High‐Temperature Compressive Properties of γ′‐Strengthened Inconel 738LC

open access: yesAdvanced Engineering Materials, EarlyView.
Experiments and thermophysical simulations were conducted to investigate the electron beam powder bed fusion electron beam (PBF‐EB/M) process for the γ′‐strengthened nickel‐based superalloy Inconel 738LC. The results demonstrate the impact of process‐induced microstructural variations on high‐temperature mechanical behavior, providing a basis for ...
Jan Niklas Petenati   +11 more
wiley   +1 more source

New Gamma-Spectrometry Technologies for Environmental Sciences

open access: yesJournal of Analytical Science and Technology, 2012
HPGe-spectrometers operating in underground laboratories represent the most important recent achievements in the radiometric sector mainly because of better sensitivity, which enabled to decrease a sample size by about a factor of ten, and to carry out ...
Pavel P. Povinec
doaj  

External and Internal Cracking Caused by Heat Treatment in Laser Powder Bed Fusion‐Fabricated Inconel 738LC Components

open access: yesAdvanced Engineering Materials, EarlyView.
Manufacturing problems such as heat treatment‐induced cracking hinder the widespread application of the laser powder bed fusion (LPBF) process to superalloys. In this study, cracks in the LPBF components of Inconel 738LC superalloy are characterized after heat treatment at various temperature ranges, revealing two distinct cracking behaviors.
Kosuke Kuwabara   +4 more
wiley   +1 more source

A Study on the Gamma-ray Attenuation Parameters of Some Commercial Salt Samples

open access: yesSakarya Üniversitesi Fen Bilimleri Enstitüsü Dergisi, 2020
The purpose of this study is to calculate self-attenuation correction factors, linear (LAC) /mass attenuation coefficients (MAC), half value layers (HVL) and tenth value layers (TVL) of different brands of commercial salt samples using gamma-ray ...
Canel Eke
doaj   +1 more source

On the Effect of Creep on Local Lattice Orientation in Single‐Crystal Ni‐Based Superalloy Microstructures

open access: yesAdvanced Engineering Materials, EarlyView.
During creep of a single‐crystal Ni‐based superalloy, the overall crystal orientation is observed to remain constant while the microstructure evolves. Despite the lack of macroscopic rotation, small (<1°) rotations are observed on the submicron size scale and are accommodated by counteracting rotations over the scale of several micrometers.
E. J. Payton   +3 more
wiley   +1 more source

Analysis of the 40K levels in soil using gamma spectrometry

open access: yesBrazilian Archives of Biology and Technology, 2005
Potassium-40 was determined in soil in an area with 40,000 m² situated in the western State of Pernambuco, Brazil. For radiometric measurements, the gamma spectrometry method with a high purity germanium (HPGe) detector was used.
José Araújo dos Santos Júnior   +4 more
doaj   +1 more source

The Influence of Field‐Assisted Sintering Technology (FAST) Temperature and Cooling Rate on the Microstructural Evolution in Gamma‐Titanium Aluminide Alloy GE4822

open access: yesAdvanced Engineering Materials, EarlyView.
Controlling the Field Assisted Sintering Technology (FAST) parameters, dwell temperature and cooling rate, significantly influences the microstructural evolution in titanium aluminide GE4822. Significant γ‐lamellar colonies develop only upon cooling through the α‐transus.
Jack Krohn, James Pepper, Martin Jackson
wiley   +1 more source

Intermediate Resistive State in Wafer‐Scale Vertical MoS2 Memristors Through Lateral Silver Filament Growth for Artificial Synapse Applications

open access: yesAdvanced Functional Materials, EarlyView.
In MOCVD MoS2 memristors, a current compliance‐regulated Ag filament mechanism is revealed. The filament ruptures spontaneously during volatile switching, while subsequent growth proceeds vertically through the MoS2 layers and then laterally along the van der Waals gaps during nonvolatile switching.
Yuan Fa   +19 more
wiley   +1 more source

Home - About - Disclaimer - Privacy