Forming Parameters and Optimization of A5052 in SPIF Process
Materials Science Forum, 2023 Forming a metallic sheet along with the consideration of computer simulation and experiment had benefited the milling industry for a long time. The ideal forming, without an error, is a concerning topic. So, the computer simulation had the advantage then direct forming.
Krishna Singh Bhandari +4 more
openaire +2 more sources
Analysing the mechanisms of failure in polycarbonate sheets deformed by SPIF
Journal of Materials Research and Technology© 2024 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY license (http://creativecommons.org/licenses/by/4.0/).
A. Rosa-Sainz +5 more
openaire +4 more sources
Geometry Compensation Methods for Increasing the Accuracy of the SPIF Process
Key Engineering Materials, 2021 Despite years of supporting research, commercial use of the Single Point Incremental Forming process remains very limited. The promised flexibility and lack of specific tooling is contradicted by its highly complex deformation mechanics, resulting in a process that is easy to implement but where workpiece accuracy is very difficult to control.
Yannick Carette +2 more
openaire +2 more sources
Ductile Fracture Analysis in Nakazima vs. SPIF Tests
Advances in Science and Technology, 2023 The Forming Limit Curve (FLC) shows the limit combinations of principal strains on the sheet surface that can be successfully achieved before necking appears. Above the FLC, Atkins in 1996 proposed the existence of an unstable region where localized necking develops before reaching at the Fracture Forming Limit (FFL).
Marcos Borrego Puche +4 more
openaire +2 more sources
Forming Parameters on Friction during Single Point Incremental Forming
Advances in Materials Science and Engineering, 2022 Friction in the single point incremental forming (SPIF) process is the main factor affecting the surface quality and forming performance of the workpiece.
Qing Xu, Zimeng Yao
doaj +2 more sources
Predictors of Suboptimal Peak Inspiratory Flow in Patients with Acute Exacerbation of Chronic Obstructive Pulmonary Disease in Clinical Practice [PDF]
Tuberculosis and Respiratory DiseasesBackground Incorrect inhalation technique is a primary cause of therapeutic failure in chronic obstructive pulmonary disease (COPD), leading to increased exacerbation frequency.
Natalia V. Trushenko +8 more
doaj +2 more sources
Effect of the Number of Gallate Groups of Polyphenols on the Structure, Gel Properties, and Biological Activity of Soy Protein Fibrils [PDF]
FoodsAmyloid fibril hydrogels prepared via protein acid heating currently exhibit inadequate gel properties and biological activity. These limitations can be addressed by modifying the amyloid fibrils with polyphenols.
Tianhe Xu +8 more
doaj +2 more sources
Advances in Materials Science and Engineering, 2019 With increasing design complexities of thin-walled parts, the requirement of enhanced formability has impeded the development of the single point incremental forming (SPIF) process.
Mingshun Yang +3 more
doaj +2 more sources
Rekayasa Mesin, 2020 In this study, the single point incremental forming (SPIF) method was applied to the half spherical-shaped vent cap products with 1mm thickness of aluminium. The dimensions of the blank before forming is 1x Ø225mm, and the final dimensions of the product
Aida Mahmudah +3 more
doaj +3 more sources
Experimental Investigation of Load-Bearing Capacity in EN AW-2024-T3 Aluminum Alloy Sheets Strengthened by SPIF-Fabricated Stiffening Rib. [PDF]
Materials (Basel)Khalaf HI +5 more
europepmc +3 more sources