Results 51 to 60 of about 154,161 (301)

A Soft Robotic Device for Targeted Massage Therapy of Residual Limbs

Advanced Robotics Research, EarlyView.
Residual limb edema after amputation can hinder recovery and delay prosthetic fitting. This study presents a soft‐robotic wearable device that delivers sequential compression through pneumatic McKibben actuators. By replicating the principles of manual lymphatic drainage, the device generates controlled mechanotherapeutic pressure patterns, providing a
Maria Grazia Polizzotto, Alessio Capecchi, Maartje Van der Lingen, Emanuele Gruppioni, Arianna Menciassi, Linda Paternò   +5 more
wiley   +1 more source

Stagnation point reverse flow combustor [PDF]

, 2008
A method for combusting a combustible fuel includes providing a vessel having an opening near a proximate end and a closed distal end defining a combustion chamber. A combustible reactants mixture is presented into the combustion chamber. The combustible
Jagoda, Jechiel, Neumeier, Yedidia, Seitzman, Jerry M., Weksler, Yoav, Zinn, Ben T.   +4 more
core   +1 more source

Highly‐Conductive and Micro‐Structured Transparent Glass Substrates for Efficient and Scalable Photoelectrochemical Applications

Advanced Science, EarlyView.
This work paves the way for practical photoelectrochemical water splitting devices by addressing key upscaling challenges related to substrate conductivity, absorber inhomogeneity, and mass transfer limitations. Integrated improvements in substrate engineering, material processing, device architecture, and operational conditions allow the development ...
Telmo da Silva Lopes, Jeffrey Capitão, Amin Khan, Leonardo Rodrigues, Dzmitry Ivanou, Tânia Lopes, Paula Dias, Adélio Mendes   +7 more
wiley   +1 more source

Modeling heat and mass transfer in Williamson nanofluid stagnation flow: Influence of porosity, chemical reaction, and internal heating

Chemical Engineering Journal Advances
Stagnation point flow of non-Newtonian fluids is crucial in understanding fluid behaviour in cooling systems, thrust bearings and other applications involving polymers and suspensions.2,2 The present work explores the heat and mass transfer for ...
Shital Sobale, Jagadish V. Tawade, Ali B.M. Ali, Dana Mohammad Khidhir, Muyassar Norberdiyeva, F.F. Al-Harbi, Nitin Satpute, Nidhal Ben Khedher   +7 more
doaj   +1 more source

Influence of heterogeneous-homogeneous reactions in thermally stratified stagnation point flow of an Oldroyd-B fluid

Results in Physics, 2016
This communication explores the effects of homogeneous-heterogeneous reactions in thermally stratified mixed convection flow of an Oldroyd-B fluid. Flow situation is addressed when the diffusion coefficients of the reactant and auto catalyst are equal ...
T. Hayat, Zakir Hussain, A. Alsaedi
doaj   +1 more source

Endothelial GPR68 Is Essential for Arteriogenesis and Represents a Therapeutic Target in a Model of Peripheral Artery Disease

Advanced Science, EarlyView.
Endothelial GPR68 is identified as a critical regulator of collateral artery growth in peripheral artery disease. Genetic and pharmacological evidence demonstrates that GPR68 integrates hemodynamic cues to drive monocyte recruitment and inflammatory remodeling, thereby promoting collateral arteriogenesis and tissue perfusion after ischemia ...
Yiyan Song, Senyi Peng, Zhilei Huang, Miao Yu, Mingyue Wu, Yuexin Zhu, Zeyi Zhou, Yongshan Liu, Yalin Zhang, Yu Huang, Zhongxing Wang, Fu‐Li Xiang, Jie Xu   +12 more
wiley   +1 more source

Bioconvection effect in the Carreau nanofluid with Cattaneo–Christov heat flux using stagnation point flow in the entropy generation: Micromachines level study

Open Physics, 2023
The addition of gyrotactic microbes in the nanoparticles is essential to embellish the thermal efficiency of many systems such as microbial fuel cells, bacteria-powered micro-mixers, micro-volumes like microfluidics devices, enzyme biosensor, and chip ...
Li Shuguang, Ali Farhan, Zaib A., Loganathan K., Eldin Sayed M., Ijaz Khan M.   +5 more
doaj   +1 more source

MHD THREE-DIMENSIONAL STAGNATION-POINT FLOW OF A MICROPOLAR FLUID [PDF]

, 2011
The steady three-dimensional stagnation-point flow of an electrically conducting micropolar fluid in the absence and in the presence of a uniform external electromagnetic field (E0,H0) is analyzed and some physical situations are examined. In particular,
Borrelli, Alessandra, Giantesio, Giulia, Patria, Maria Cristina   +2 more
core  

Optimized cross-slot flow geometry for microfluidic extension rheometry [PDF]

, 2012
A precision-machined cross-slot flow geometry with a shape that has been optimized by numerical simulation of the fluid kinematics is fabricated and used to measure the extensional viscosity of a dilute polymer solution.
Gareth H. McKinley, H. Tadokoro, L. K. G. Treloar, M. A. Alves, Manuel A. Alves, Mónica S. N. Oliveira, Simon J. Haward   +6 more
core   +1 more source

Unveiling a Bulk WTaV Multicomponent Alloy With Superior Thermal Properties and Manufacturability

Advanced Science, EarlyView.
ABSTRACT Many tungsten (W)‐based medium and high entropy alloys (HEA) demonstrate superior microstructural stability and enhanced mechanical properties as compared to pure W, effectively rendering them as viable candidate materials for extreme environments such as nuclear fusion, aerospace applications, and so on.
Ishtiaque K. Robin, Skye N. Supakul, Shalini Tripathi, Eda Aydogan, Matthew T. Vigil, Caleb Hatler, Bochuan Sun, Akshay Korpe, Enrique Martinez, Saryu J. Fensin, Dan J. Thoma, Osman El‐Atwani   +11 more
wiley   +1 more source