Results 121 to 130 of about 94,552 (259)

Thermography and Sonic Anemometry to Analyze Air Heaters in Mediterranean Greenhouses [PDF]

open access: yes, 2012
The present work has developed a methodology based on thermography and sonic anemometry for studying the microclimate in Mediterranean greenhouses equipped with air heaters and polyethylene distribution ducts to distribute the warm air.
López Martínez, Alejandro   +3 more
core   +1 more source

Modelling of continuous low‐temperature emulsion co‐polymerization in 3D‐printed reactor

open access: yesThe Canadian Journal of Chemical Engineering, EarlyView.
A kinetic model for the emulsion copolymerization of butyl acrylate/styrene at low temperatures is proposed and validated against experiments with a redox initiator system. The model was successfully transferred to a 3D‐printed tubular reactor and conversions of more than 80% and small particles sizes below 40 nm were observed.
Ferel Issa   +2 more
wiley   +1 more source

In‐situ asphaltene capture with iron oxide nanoparticles in steam‐assisted gravity drainage (SAGD) for improved recovery and partial upgrading of bitumen

open access: yesThe Canadian Journal of Chemical Engineering, EarlyView.
Key improvements obtained by incorporating nanoparticles into a lab‐scale SAGD process configuration. The bar plots show enhanced oil recovery, reduced viscosity, and increased asphaltene adsorption in nanoparticle‐assisted scenarios compared with conventional SAGD.
Luis Prada   +6 more
wiley   +1 more source

An Estimation of the Heat Load Distribution on the Divertor Target Using the CSD Model

open access: yesContributions to Plasma Physics, EarlyView.
ABSTRACT Handling the heat load on the divertor target is a critical issue in the design of fusion reactors. Estimating the heat load, supported by computationally efficient simulations with varying design parameters, provides valuable input to high‐level design discussions and the development of design guidelines.
Kazuhiro Yamada   +4 more
wiley   +1 more source

Owens-Illinois liquid solar collector materials assessment [PDF]

open access: yes
From the beginning, it was noted that the baseline drawings for the liquid solar collector exhibited a distinct weakness concerning materials specification where elastomers, plastics, and foam insulation materials were utilized. A relatively small effort
Nichols, R. L.
core   +1 more source

Sheath‐assisted microfluidics for elasto‐inertial manipulation of micro/nanoparticles: From theory to biomedical applications

open access: yesDroplet, EarlyView.
This review examines sheath‐assisted elasto‐inertial microfluidics, where viscoelastic and inertial forces synergize to manipulate particles. It analyzes the underlying mechanisms, system designs, and biomedical applications, proposing future research to advance high‐precision technologies.
Huan Wang   +8 more
wiley   +1 more source

Bottlenecks‐Breaking in Zinc‐Iodine Batteries Toward Practical Implementation: A Review and Perspective

open access: yesENERGY &ENVIRONMENTAL MATERIALS, EarlyView.
Aqueous zinc–iodine batteries (Zn–I2Bs) offer promise for grid storage due to safety and cost advantages yet face critical bottlenecks: severe self‐discharge (polyiodide shuttling and HER), limited energy density, sluggish kinetics, and zinc anode instability.
Jia‐Lin Yang   +3 more
wiley   +1 more source

Efficient Kesterite Solar Cells via Scalable Doctor‐Blading of 2‐Methoxyethanol‐Based Molecular Ink

open access: yesENERGY &ENVIRONMENTAL MATERIALS, EarlyView.
A new record efficiency of 13.26% has been achieved for doctor‐bladed CZTSSe solar cells, fabricated for the first time from an MOE‐based molecular ink in ambient air. Cu2ZnSn(S,Se)4 (CZTSSe) thin‐film solar cells have garnered significant interest owing to their appealing properties, such as earth‐abundant composition, environmental friendliness, high
Yanmei Deng   +9 more
wiley   +1 more source

Analysis and testing of two-dimensional vented Coanda ejectors with asymmetric variable area mixing sections [PDF]

open access: yes
The analysis of asymmetric, curved (Coanda) ejector flow has been completed using a finite difference technique and a quasi-orthogonal streamline coordinate system.
Armstrong, R. L.   +3 more
core   +1 more source

From Disruption to Stabilization: A Functional Governance Perspective on the Renewable Energy Transition in Montenegro

open access: yesEnvironmental Policy and Governance, EarlyView.
ABSTRACT As global climate ambitions intensify, the key challenge lies not in setting renewable energy targets but in designing governance systems that can translate them into lasting transformation. The transition management literature has advanced a valuable research agenda for initiating change through niche innovations and participatory arenas in ...
Alexander L. Q. Chen‐Florea   +2 more
wiley   +1 more source

Home - About - Disclaimer - Privacy