Results 51 to 60 of about 194,524 (260)
Journal of Materials Research and TechnologyIn this study, the common challenges of 316H/TC4 composite plate, such as weak interface bonding, poor coordinated deformation and serious warpage, were caused by the mismatch of thermodynamic properties of dissimilar metals during the traditional ...
Shiyi Zhang +7 more
doaj +1 more source
Effect of substrate on metallographic corrosion of cladding in stainless/carbon steel bimetal plate
Results in Physics, 2020 The effect of substrate on metallographic corrosion of cladding in stainless/carbon steel bimetal plate is investigated in this paper. The metallographic observation results show that the presence of substrate (carbon steel) would lead to the over ...
Hao Li +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
Nondestructive Testing of Welded Composite Metal Foams
Advanced Engineering Materials, EarlyView.X‐ray computed tomography (CT) is used to evaluate welded steel–steel composite metal foam (CMF) joints of two density classes. It reports variation in postweld spatial void distribution and correlates it to weld‐induced changes, mechanical performance, and failure within welded CMF panels.
Chinmaya Prerana Inguva +2 more
wiley +1 more source
CrystalsS32750 dual-phase stainless steel (DSS) wires were prepared by cold drawing with a strain of ε = 0~3.6. The mechanical behavior and microstructural evolution of these DSS wires at different strains were investigated.
Hong Gao +8 more
doaj +1 more source
Advances in Materials Science and Engineering, 2020 In order to research the effect of heat treatment on the microstructure and corrosion resistance of stainless/carbon steel bimetal plate, the annealing process at 700°C with different times was carried out for stainless/carbon steel bimetal plate ...
Hao Li +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Aluminum and nitride coatings are used in industry because they are hard, resist wear, and protect against oxidation. Adding boron can improve friction behavior and other properties. This study tests coatings on surfaces with different finishes. Results show smoother surfaces perform better, while rough ones wear faster, although coatings can reduce ...
Adrián Claver +9 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study shows that superalloys used in aircraft engine disks become much more prone to deformation at high temperatures if they have been strained during manufacturing. This effect increases with the level of prior strain but eventually reaches a limit.
Fabio Machado Alves da Fonseca +9 more
wiley +1 more source
Journal of Materials Research and TechnologyThis study examines the impact of high-speed cold rolling deformation on the microstructure and corrosion resistance of selectively laser melted (SLMed) 316L stainless steel after solution treatment at 1100 °C for 0.25 h in a simulated proton exchange ...
Shaohua Zhang +8 more
doaj +1 more source
Journal of Pharmacy and Bioallied Sciences, 2012 Aim: The aim of the study was to compare the frictional resistance of titanium, self-ligating stainless steel, and conventional stainless steel brackets, using stainless steel and titanium molybdenum alloy (TMA) archwires.
Syed Altaf Khalid +2 more
doaj +1 more source