Results 141 to 150 of about 904 (182)
Some of the next articles are maybe not open access.
Control of Multilevel STATCOMs
2014Control strategies suitable for multilevel STATCOMs are reviewed in this chapter. First of all, the models are systematically deducted and especial emphasis is given to the dynamic and steady state analysis in order to facilitate the study of the control techniques.
Javier Muñoz +2 more
openaire +1 more source
Coordination of DFIG and STATCOM in a power system
2012 IEEE International Symposium on Industrial Electronics, 2012Coordination of STATCOM and DFIG becomes necessary during steady-state as STATCOM exists in the system to improve the fault-ride through capability of DFIG. This paper aims to perform the coordination by means of minimizing the power loss of the system. As reactive power flow in the system has direct impact on the loss of the system, utilizing reactive
Miad Mohaghegh Montazeri, David Xu 0001
openaire +1 more source
Modeling and Control of STATCOMs
2014This chapter addresses modeling and control of the STATCOM and associated power system. Component and system level models of the STATCOM appropriate to objectives are covered. Distinction is made between control objectives on the basis of time scale. For some objectives quasi steady state modeling, where electrical network can be modeled with phasors ...
Jain, Amit Kumar, Behal, Aman
openaire +2 more sources
Integration of a StatCom and Battery Energy Storage
IEEE Power Engineering Review, 2001The integration of an energy storage system, such as battery energy storage (BESS), into a FACTS device can provide dynamic decentralized active power capabilities and much-needed flexibility for mitigating transmission level power flow problems. This paper will introduce an integrated static synchronous compensator (StatCom)/BESS for the improvement ...
Z. Yang +4 more
openaire +1 more source
SSR Mitigation With a New Control of PV Solar Farm as STATCOM (PV-STATCOM)
IEEE Transactions on Sustainable Energy, 2017This paper presents a novel control of a large-scale PV solar farm as STATCOM, termed PV-STATCOM, for alleviation of subsynchronous resonance (SSR) in a steam turbine driven synchronous generator connected to a series compensated transmission line. During nighttime, the PV solar farm can operate as a STATCOM with its entire inverter capacity for SSR ...
Rajiv K. Varma, Reza Salehi
openaire +1 more source
Modular multilevel STATCOM with energy storage
2016 11th International Conference on Industrial and Information Systems (ICIIS), 2016A configuration of Energy storage (ES) integrated STATCOM is presented in this paper. Such type of system is generally referred as E-STATCOM (STATCOM+ES) in the literature. In this paper, a Modular Multilevel Converter (MMC) is used as a STATCOM and energy storage is integrated at the DC link of MMC.
Ch. Anil Bharadwaj, Suman Maiti
openaire +1 more source
Study of a state-of-the art M-STATCOM
2015 IEEE International Conference on Industrial Technology (ICIT), 2015This paper presents a novel static synchronous compensator based on the state-of-the-art modular multilevel converter called M-STATCOM. In order to support the DC bus voltage, maintain the stability of DC-link capacitor voltage, obtain an output voltage with low harmonic content and compensate reactive power under unbalanced load operation, a direct ...
Syed Ali Kamran, Javier Muñoz 0001
openaire +1 more source
2014
This chapter reviews the control systems used to enable STATCOMs to carry out their most important task, which is to deliver reactive power to the electrical grid. Later on, other control systems designed for more advanced applications are discussed, such as compensating the nonlinear loads.
Dionisio Ramirez +3 more
openaire +1 more source
This chapter reviews the control systems used to enable STATCOMs to carry out their most important task, which is to deliver reactive power to the electrical grid. Later on, other control systems designed for more advanced applications are discussed, such as compensating the nonlinear loads.
Dionisio Ramirez +3 more
openaire +1 more source
10MVA STATCOM installation and commissioning
2007 7th Internatonal Conference on Power Electronics, 200710MVA STATCOM has been developed by Hyosung Corporation under a joint research project with KEPRI (Korean electrical power research institute). It has been installed and commissioned at Hyosung factory in Changwon Korea on March, 2007. This paper describes configuration of 10MVA STATCOM system and the result of installation and commissioning.
null Youngseong Han +4 more
openaire +1 more source