Results 21 to 30 of about 14,105 (205)
Ain Shams Engineering Journal, 2018 In this paper, an approach for optimal placement of D-STATCOM in mesh distribution systems using sensitivity approaches is proposed. The main contributions of the paper are as follows: (i) Optimal D-STATCOM placement based on the new voltage sensitivity ...
Atma Ram Gupta, Ashwani Kumar
doaj +1 more source
One-Cycle Control of Three-Phase Five-Level Diode-Clamped STATCOM
Energies, 2021 This paper presents a new multilevel one-cycle control (OCC) technique for a five-level diode-clamped multilevel converter (DCMC)-based static VAR compensator (STATCOM).
In Wha Jeong, Tae Hyun Sung
doaj +1 more source
Effect of cascade STATCOM on stabilising voltage in high voltage direct current
The Journal of Engineering, 2019 Yongfu high voltage direct current (HVDC) project in Yunnan is the main access to send the power out and also an important part of the channel of transmission of power in west to east in China southern power grid. However, the Funing Converter Station of
Li Jiaqi, Wen Jun, Liu Helin, Yu Shiyou
doaj +1 more source
IEEE Access, 2019 Photovoltaic (PV) solar farms are typically dormant at nighttime with their entire expensive assets unused. This paper presents the first in Canada (and perhaps first in the world) utility demonstration of a novel nighttime and daytime technology of ...
Rajiv K. Varma +3 more
doaj +1 more source
Fuzzy second order sliding mode control of a unified power flow controller [PDF]
, 2019 Purpose. This paper presents an advanced control scheme based on fuzzy logic and second order sliding mode of a unified power flow controller. This controller offers advantages in terms of static and dynamic operation of the power system such as the ...
Boudjema, Zinelaabidine +2 more
core +3 more sources
Design of a prototype D-STATCOM using DSP controller for voltage sag mitigation [PDF]
, 2006 This paper presents the design of a prototype distribution static compensator (D-STATCOM) for load compensation in an unbalanced distribution system. The D-STATCOM is intended to replace the widely used static VAr compensator (SVC).
Bashi, Senan M. +4 more
core +1 more source
Ain Shams Engineering Journal, 2017 Power flow study in a power network embedded with FACTS device requires effort in program coding. Moreover, Newton-Raphson method should be modified by embedding injected power components into the algorithm.
Ahmet Mete Vural +1 more
doaj +1 more source
Secure High DER Penetration Power Distribution Via Autonomously Coordinated Volt/VAR Control [PDF]
, 2020 Traditionally voltage control in distribution power system (DPS) is performed through voltage regulating devices (VRDs) including on load tap changers (OLTCs), step voltage regulators (SVRs), and switched capacitor banks (SCBs). The recent IEEE 1547-2018
Joseph, Anto +2 more
core +1 more source
Voltage Stability Analysis of Grid-Connected Wind Farms with FACTS: Static and Dynamic Analysis [PDF]
, 2015 Recently, analysis of some major blackouts and failures of power system shows that voltage instability problem has been one of the main reasons of these disturbances and networks collapse.
Angeles-Camacho C. +9 more
core +2 more sources
Optimal Location and Parameter Setting of STATCOM Device Based PSO for Iraqi Grid Voltage Profile Enhancement and Power Losses Minimizing [PDF]
Engineering and Technology Journal, 2019 The main goal of this work is to enhance the Voltage stability by using optimum location and parameters setting of STATCOM device. The parameters are the magnitude of the output voltage 𝑉𝑉𝑅 and the angle 𝛿𝑉𝑅, these parameters are taken to control the ...
Rashid Al-Rubayi, Mohammed Eesee
doaj +1 more source