Results 11 to 20 of about 24,864 (263)
Advances in Civil Engineering, 2020 To investigate the dynamic splitting tensile mechanical property of limestone under coupled static and dynamic state, the dynamic split tensile tests of limestone under one-dimensional coupled static and dynamic load with different strain rates were ...
Qi Ping +3 more
doaj +1 more source
The Influence of Deformation Method on the Microstructure and Properties of Magnesium Alloy WE43 [PDF]
Archives of Metallurgy and Materials, 2018 The article presents tests results of the influence of deformation methods on the microstructure and properties of alloy WE43. There were direct extrusion tests and extrusion with KoBo method performed.
I. Bednarczyk +3 more
doaj +1 more source
Jurnal Teknik Sipil dan Perencanaan, 2023 R.H. Bridge Fisabilillah (Bridge I) is a cable-stayed bridge, included in the series of Barelang Bridges (Batam-Rempang-Galang) which were built from 1992 to 1998. With the service life of the bridge reaching 25 years, it is necessary to check the health
Hinawan Teguh Santoso, Irfan Hidayat
doaj +1 more source
Experimental Study on Impact Behavior of Concrete Panel with and without Polypropylene Macrofibers
Buildings, 2023 Macrofibers have often been used to increase the tensile strength, durability, crack resistance, spalling, impact resistance, and toughness of concrete.
Kwangsoo Youm, Jiho Moon
doaj +1 more source
Journal of Hebei University of Science and Technology, 2017 According to the tensile properties of typical aerospace material TC11 titanium alloy, the stress-strain relationship is studied using the quasi-static tensile test at different strain rates, and the tensile fracture morphology is analyzed with SEM.
Qiulin NIU, Ming CHEN, Weiwei MING
doaj +1 more source
Effect of Laser Surface Treatment on Some Mechanical Properties of Low Carbon Steel [PDF]
Engineering and Technology Journal, 2012 This research aims to study the effect of localized laser surface treatment onmechanical behavior of low carbon steel. Laser Cw Nd : YAG was used in thetreatment hardening of the specimens for different laser energy (2.7,3.3,4.37100J ),with time interval
Asaad K. Hamza +2 more
doaj +1 more source
Metrology and Measurement Systems, 2014 The aim of this study was to estimate the measurement uncertainty for a material produced by additive manufacturing. The material investigated was FullCure 720 photocured resin, which was applied to fabricate tensile specimens with a Connex 350 3D ...
Adamczak Stanisław +2 more
doaj +1 more source
Case Studies in Construction Materials, 2023 In order to compare the effects of carbon fiber and carbon nanofiber on the static and dynamic mechanical properties of concrete, the static mechanical tests, dynamic compression test and dynamic splitting tensile test were carried out on carbon fiber ...
Tao Chen +4 more
doaj +1 more source
Effects of Al-Si Coating on Static and Dynamic Strength of Spot-Welded Hot-Stamping Steel Joints
Metals, 2021 Al-Si is the most popular coating used to prevent oxidation on the surfaces of hot-stamped steel sheets during the heating process. However, like other coatings, it affects the strength of the spot welds in joining the hot-stamped steel parts.
Ali Afzal +2 more
doaj +1 more source
Applied Sciences, 2021 The present paper focuses on the configuration possibilities of post -processor influencing mechanical properties of a given test sample produced by the FDM printer from different materials.
Jozef Török +6 more
doaj +1 more source