Results 301 to 310 of about 1,824,100 (361)
Sensor fault diagnosis strategy based on rotor flux observers in three-phase induction motor drive. [PDF]
Sci RepTran CD, Kuchar M, Sotola V, Nguyen PD.
europepmc +1 more source
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Pre-swirl Stator and Propeller/Stator Efficiency
Day 1 Tue, September 17, 1991, 1991A new method for improving the propeller efficiency due to locating a pre-swirl stator array has been developed by applying linearized lifting surface theory. This method has been applied on general stators and in particular stators of low aspect ratio. The obtained results of the stator 1nduced velocity are in exact agreement with the low aspect ratio
M. M. Gaafary, M. M. Mosaad
openaire +1 more source
Convective condensation in a stator–rotor–stator spinning disc reactor
AIChE Journal, 2016Centrifugal intensification of condensation heat transfer in the rotor–stator cavities of a stator–rotor–stator spinning disc reactor (srs‐SDR) is studied, as a function of rotational velocity ω, volumetric throughflow rate , and average temperature driving force .
de Beer, M.M. +3 more
openaire +4 more sources
Rotor–stator devices: The role of shear and the stator
Chemical Engineering Research and Design, 2012High shear rotor-stator mixers are widely used in process industries including the manufacture of many food, cosmetic, pharmaceutical, and health care products. Many of these products involve emulsification where the drop size distribution affects the processing and the product properties.
Rodgers, T. L., Cooke, M.
openaire +1 more source
Analysis of Stator-Stator Clocking in a Transonic Turbine
Volume 6: Turbo Expo 2007, Parts A and B, 2007Clocking, i.e. the relative pitch-wise positioning between two successive vanes with the same amount of airfoils, has been demonstrated to bring potential aero-thermal benefits in several recent studies. Indeed, across a vane pitch, a variation of both time-averaged and time-resolved quantities is induced. In order to advance the knowledge on clocking,
N. Billiard +3 more
openaire +1 more source
2013 66th Annual Conference for Protective Relay Engineers, 2013
When considering protection for the generator stator, the engineer must balance the expense of applying a particular relay or relay system against the consequences of losing a generator. The total loss of a generator may not be catastrophic if it represents a small percentage of the investment in an installation.
Johnny Simms, Suparat Pavavicharn
openaire +1 more source
When considering protection for the generator stator, the engineer must balance the expense of applying a particular relay or relay system against the consequences of losing a generator. The total loss of a generator may not be catastrophic if it represents a small percentage of the investment in an installation.
Johnny Simms, Suparat Pavavicharn
openaire +1 more source
IEEE Industry Applications Magazine, 1998
Partial discharge tests can determine which motor and generator stator windings are experiencing insulation problems. A deteriorated winding has a PD activity which can be 30 times or more higher than a winding in good condition. This great difference in PD activity enables even nonspecialized maintenance personnel to identify the few motors or ...
Greg Stone, Joe Kapler
openaire +1 more source
Partial discharge tests can determine which motor and generator stator windings are experiencing insulation problems. A deteriorated winding has a PD activity which can be 30 times or more higher than a winding in good condition. This great difference in PD activity enables even nonspecialized maintenance personnel to identify the few motors or ...
Greg Stone, Joe Kapler
openaire +1 more source
Failure analysis of general stator and uniform wall thickness stator
Engineering Failure Analysis, 2018Abstract Stator lining of positive displacement motor (PDM) is prone to generate thermal fatigue failure because of viscoelastic hysteresis of the rubber material. Based on the thermo-mechanical coupling modeling and rubber material testing, finite element method was used to study the effect of environment temperature and thermo-viscoelastic ...
Changshuai Shi +3 more
openaire +1 more source
2016
The chapter deals with stator winding faults. Assessments of different types of stator winding fault are discussed in this chapter. Both steady-state and transient current-based diagnosis are covered. Sequence component-based stator fault diagnosis is presented. Park plane is sometime used for fault diagnosis.
Subrata Karmakar +3 more
openaire +1 more source
The chapter deals with stator winding faults. Assessments of different types of stator winding fault are discussed in this chapter. Both steady-state and transient current-based diagnosis are covered. Sequence component-based stator fault diagnosis is presented. Park plane is sometime used for fault diagnosis.
Subrata Karmakar +3 more
openaire +1 more source