Results 21 to 30 of about 1,718,853 (194)
IET Electric Power Applications, 2021 In this work, a novel dual‐stator hybrid excited linear flux switching machine (DSHELFSM) is proposed. The proposed machine is suitable for long‐stroke applications as all the excitation sources are mounted on a short mover and the stator is completely ...
Basharat Ullah +4 more
doaj +1 more source
High Voltage, 2018 Slot discharge studies are very important from the insulation diagnosis perspective. Further in practice, testing of rotating machines with power frequency requires sources which are quite bulky and costly.
Ramesh P. Nair +3 more
doaj +1 more source
The Journal of Engineering, 2019 Wind energy conversion systems (WECSs) require a suitable control to maximise the power generated by wind turbines independently on the wind conditions.
Cherngchai Sompracha +2 more
doaj +1 more source
Design route towards a PM machine for rotorcraft environments
The Journal of Engineering, 2019 This paper discusses the design route followed in the development of a permanent magnet (PM) machine for electrical power generation on board a rotorcraft (helicopter).
Dominic North +4 more
doaj +1 more source
Finite element analysis of a modular brushless wound rotor synchronous machine
The Journal of Engineering, 2019 This study presents a comparative study of different modular brushless wound rotor synchronous machines (MB-WRSM) using non-overlapping fractional slot double-layer concentrated windings.
Huong Thao Le Luong +5 more
doaj +1 more source
Energies, 2021 About ten hydroelectric power plants realized from 1970 to 1990 in Romania are confronted with stator overheating. The developed mathematical model analyzes the voltage stability based on modal analysis of the Jacobian matrix, identifying the hazardous ...
Victorita Radulescu
doaj +1 more source
Performance of multi-stage axial-flux machines with MMEs
The Journal of Engineering, 2019 This study covers the investigation into the reduction of rare-earth magnets in a permanent magnet (PM) machine via the use of multiple rotors to enable a PM generator to be comprised of mixed magnetic elements, hereafter referred to as MME, by ...
Anthony James Spargo
doaj +1 more source
Utilisation of grain-oriented electrical steel in permanent magnet fractional-slot modular machines
The Journal of Engineering, 2019 The performance improvement of using grain-oriented electrical steels (GOES) in the stator of PM fractional-slot modular machines is analysed in this study.
Jaime Maraví-Nieto +3 more
doaj +1 more source
Design methodology for a special single winding based bearingless switched reluctance motor
The Journal of Engineering, 2017 Bearingless switched reluctance motors (BSRMs) have both magnetic bearing as well as conventional motor characteristics which make them suitable for diverse industrial applications.
Madhurjya Dev Choudhury +5 more
doaj +1 more source
Integral sliding mode control for back-to-back converter of DFIG wind turbine system
The Journal of Engineering, 2020 In this study, an integral sliding mode control approach for controlling the power electronics converters of a doubly-fed induction generator (DFIG) wind turbine system is presented.
Adel Merabet +5 more
doaj +1 more source