Results 231 to 240 of about 9,657,274 (288)
Dynamic energy performance assessment using a digital shadow for sludge incineration in wastewater treatment plants. [PDF]
Sci RepAdibimanesh B +4 more
europepmc +1 more source
Interfacial solidification behavior during liquid metal-water interactions. [PDF]
iScienceZhang L, Deng C, Zheng M, Liu X.
europepmc +1 more source
Sustainable Process Systems Modeling of a Geothermal Powered Direct Air Capture and District Heating Concept. [PDF]
ACS OmegaIshaq H.
europepmc +1 more source
Flow Rate Analysis of Compressible Superheated Steam Through Pressure Reducing Valves
Energy, 2017 Steam flow is the main form for energy transfer in power plants, process industries, etc. The flow rate of the steam relates to the energy transfer amount directly.
Fu-Qiang Chen +2 more
exaly +2 more sources
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Downhole Steam Quality and Flow Rate Estimation in Selective Steam Well Injection Completions
SPE Latin American and Caribbean Petroleum Engineering Conference, 2020Abstract Objectives/Scope: To determine quality, mass and volumetric flows in each sands where steam has been injected using well completions with selectivity elements under critical regime. From pressuretemperature logs and ILT run in wells, were used to estimate density, volumetric and mass flow of steam, and heat injected at each ...
Hector A Rodriguez-Prada +1 more
openaire +1 more source
Thin-layer Steam Distillation of Fermented Grains: Effects of Steam Flow Rate and Temperature
International Journal of Food Engineering, 2012Abstract Bioethanol was obtained by distillation of solid-state fermented biomass. In this process, the objective material is ethanol and it is not necessary to consider other contents, like aromatic compounds, as essential in Chinese traditional alcohol distillation.
Jingju Chen +4 more
openaire +1 more source
Rate of droplet deposition in steam–water annular flow and effect of a flow obstacle
Nuclear Engineering and Design, 2011Abstract Deposition rate of droplets in steam–water annular two-phase flow was measured using a 5 mm diameter vertical round tube as a test section. In the experimental conditions tested in this work, the droplet mass transfer coefficient decreased with an increase in the droplet concentration in the gas core flow and with an increase in the length ...
Tomio Okawa +2 more
openaire +1 more source
Science and Innovation, 2022
Introduction. The results of experimental studies, which given in various scholarly research sources, have shown that changes in the flow structure and the formation of a breakaway near a bushing (with a decrease in power) begins in the outlet nozzle and gradually spreads towards the last stage of low-pressure cylinder.
O. Shubenko +3 more
openaire +1 more source
Introduction. The results of experimental studies, which given in various scholarly research sources, have shown that changes in the flow structure and the formation of a breakaway near a bushing (with a decrease in power) begins in the outlet nozzle and gradually spreads towards the last stage of low-pressure cylinder.
O. Shubenko +3 more
openaire +1 more source
Dimension calculations for low flow rate steam injection experiments
The Physics of Fluids, 1986The Grassberger–Procaccia dimension is determined from pressure and temperature measurements in a pool of water agitated by steam injection. For this complex flow system, three distinct values of dimension ranging from ∼4.2 to ∼8.0 (corresponding to three different measurement locations) are obtained.
C. K. B. Lee +2 more
openaire +1 more source