Results 31 to 40 of about 13,179 (311)
Study on axial compressive bearing capacity of composite shear wall with double-skin steel plate
工程科学学报, 2017 This study conducted a steel-plate buckling analysis and a stress analysis of confined core concrete in a composite shear wall with a double-skin steel plate.
HAO Ting-yue, CAO Wan-lin
doaj +1 more source
Wood-steel composite shear walls with openings
International Journal of Engineering & Technology, 2020 This paper reports an investigation into the behaviour of wood-steel composite shear walls, consisting of strand laminated lumber boundary frames with infill steel plates. Recently it has been shown that wood-steel composite shear wall systems can offer various advantages over code-approved wood frame shear walls, including architectural flexibility ...
Tzanetis Vogiatzis +2 more
openaire +2 more sources
Frontiers in MaterialsIn the paper, an innovative shear wall, which is referred to as steel fiber reinforced concrete (SFRC) shear wall with concrete filled steel tube (CFST) columns, is introduced, based on the high bearing capacity and large stiffness of concrete filled ...
Peibo You +5 more
doaj +1 more source
Experimental Investigation of Steel Plate Shear Walls under Shear‐Compression Interaction
Shock and Vibration, 2019 Four scaled one‐storey single‐bay steel plate shear wall (SPSW) specimens with unstiffened panels were tested to determine their behaviour under cyclic loadings. The shear walls had moment‐resisting beam‐to‐column connections. Four different vertical loads, i.e., 300 kN, 600 kN, 900 kN, and 1200 kN, representing the gravity load of the upper storeys ...
Yang Lv +5 more
openaire +2 more sources
Advances in Civil Engineering, 2018 Four test pieces with different steel plate center-to-center distances and reinforcement ratios are subjected to low-cycle repeat quasistatic loading to optimize properties as failure mode, hysteretic curve, skeleton curve, energy dissipation parameters,
Min Gan, Yu Yu, Liren Li, Xisheng Lu
doaj +1 more source
Investigation of the effect of thickness and type of steel on the behavior of steel plate shear wall under blast loads [PDF]
Journal of Structural and Construction Engineering, 2020 One of the aims of passive defense, is designing of safe structures against explosion. Nowadays, with expansion of bombing attacks into the building, it is necessary to investigate the behavior of structures under blast loads.
Hossein Khorshidi Mianaei +2 more
doaj +1 more source
Građevinar, 2022 Experiments are conducted on five shear wall specimens of varying design and structural measures in order to investigate seismic behaviour of a composite shear wall with the steel-reinforced concrete frame and an embedded perforated-steel plate.
Zhongyi Zhou +3 more
doaj +1 more source
Advances in Civil Engineering, 2019 To study the antiseismic performance of the high-strength concrete composite shear wall with built-in steel plates, an experiment on a high-strength concrete composite shear wall with four built-in steel plates (SPRCW-1∼4) was set up.
Yu Yu +4 more
doaj +1 more source
Shear Performance of Slit Steel Plate Shear Walls Reinforced with Cfrp
Yipeng Du +6 more
openaire +2 more sources
X‐Ray Tomography Analysis of Damage Mechanisms in Metal Matrix Syntactic Foams During Compression
Advanced Engineering Materials, EarlyView.In situ synchrotron X‐ray tomography is used to investigate the internal damage mechanisms of AlSi12 metal matrix syntactic foam with ceramic hollow spheres during compressive loading. It is concluded that a homogeneous distribution of the second‐phase filler material results in a sequential collapse in a localized region; this leads to controlled and ...
Indrajeet Tambe +8 more
wiley +1 more source