Results 51 to 60 of about 67,208 (284)
Interactive industrial application to represent isothermal sections of multi component phase diagram [PDF]
, 2019 “Make the slag and the steel will make itself” is an old phrase in steelmaking. The converter or basic oxygen furnace (BOF) process is a necessary step in the steel production during which carbon, phosphorus and other impurities present in the hot metal,
Bellemans, Inge +4 more
core +1 more source
Application of Raman and Photoluminescence Spectroscopy to MgO‐C Refractories
Advanced Engineering Materials, EarlyView.Visible to near infrared luminescence of MgO is studied on MgO‐C bricks and nominally pure MgO powder, with focus on two similar sharp high‐intensity signals, at 699 and 871 nm, each surrounded by symmetrical sidebands. The nature of these sidebands is investigated by temperature‐dependent spectroscopic measurements, confirming phonon involvement by ...
Julia Richter +5 more
wiley +1 more source
Preparation of modified porous steel slag/rubber composite materials and its properties
工程科学学报, 2019 High value-added utilization of solid wastes, such as the development of an inexpensive inorganic rubber filler, is one of the important approaches of sustainable development.
ZHANG Hao, ZHANG Xin-yu
doaj +1 more source
The Basic Study on the Prepartion of Steel Slag Cement with Gas Quenching Steel Slag [PDF]
The Open Materials Science Journal, 2011 Through experiment study of the contents of gas quenching steel slag f-CaO, mineral composition, grindability, the physical property and hydrate mechanics of steel slag cement made of gas quenching steel slag, as well as through analysis of gas quenching steel slag cement economic benefit and brief introduction to the granulation technology and its ...
openaire +1 more source
Advanced Engineering Materials, EarlyView.The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann +6 more
wiley +1 more source
Preparation and Performance Testing of Steel Slag Concrete from Steel Solid Waste
BuildingsIn this paper, steel slag powder was used to replace part of the cement in road concrete, and group tests were carried out on coarse aggregates with different water–cement (W/C) ratios, different steel slag parameters, and different particle sizes.
Bao Yuan +3 more
doaj +1 more source
Evaluation of the impact factors on the leaching risk of steel slag and its asphalt mixture
Case Studies in Construction Materials, 2022 In recent years, there has been an increasing interest in steel slag asphalt mixtures. Steel slag has good mechanical properties, but there is a risk of leaching of heavy metal elements during the steel slag stockpiling process and after paving asphalt ...
Youwei Gan +4 more
doaj +1 more source
Soil Modification by the Application of Steel Slag [PDF]
, 2014 This paper provides experimental insights on the modification of a soil using electric arc furnace (EAF) steel slag, which is limitedly used as a construction material because of its volumetric instability.
Akinwumi, I. I.
core +2 more sources
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Utilization of Solid Wastes Generated From Steel Plant [PDF]
, 2015 About 12 million tons of steel slag is produced a year, which is the by-product of iron and steel manufacture, is generated in India and the most of all the slag is reused for the materials, e.g.
Kumar, Rohit
core