Results 21 to 30 of about 3,289 (243)
DETECTION OF STICK-SLIP OCCURRENCES THROUGH NEAR FIELD NOISE MEASUREMENTS
Yanbu Journal of Engineering and Science, 2010 The present study is concerned with evaluating the pin-on-disk test rig usage and the measurements conducted to recognize the occurrence of the stick-slip phenomenon.
Nadim A. Emira
doaj +2 more sources
From transmission error measurement to Pulley-Belt slip determination in serpentine belt drives : influence of tensioner and belt characteristics [PDF]
, 2009 Serpentine belt drives are often used in front end accessory drive of automotive engine. The accessories resistant torques are getting higher within new technological innovations as stater-alternator, and belt transmissions are always asked for higher ...
Dufour, Regis +3 more
core +1 more source
Friction-induced stick-slip vibration and its experimental validation
, 2020 Friction is known to cause vibration in many situations and one particular kind of friction-induced vibration is in the form of stick-slip vibration, which is of fundamental significance in science due to its ubiquitous nature.
Huang, B +4 more
core +2 more sources
Study on suppressing of stick-slip using dynamic vibration absorber
Nihon Kikai Gakkai ronbunshu, 2019 This study discussed design criteria for suppressing stick-slip using dynamic vibration absorber. First, a simplified analytical model that can quantify the effect of the dynamic vibration absorber on the occurrence and nonoccurrence conditions of stick ...
Satoru MAEGAWA, Fumihiro ITOIGAWA
doaj +1 more source
Vehicles, 2023 Inspired by the difference in the friction radii of the pads from the high-speed train brake system, stick–slip experiments for a disc–block friction system with different friction radii were carried out via a test device.
Changlin Lu +5 more
doaj +1 more source
Measurement and Analysis of Downhole Drill String Vibration Signal
Applied Sciences, 2021 Downhole drill string vibration data can provide an effective reference for research drill string vibration during drilling. In this paper, the research group used a storage-type downhole vibration measurement equipment equipped with an orthogonal, three-
Yafeng Li +4 more
doaj +1 more source
Modeling and analysis of stick-slip vibration and bit bounce in drillstrings [PDF]
, 2017 Bit bounce and stick-slip vibration are detrimental to the service life of drillstring and down-hole equipment. A two degrees-of-freedom lumped parameters model is employed to account for bit-rock interaction and coupled vibration.
Baojin Wang, Fushen Ren
core +1 more source
Study on Drill String Stick-slip Vibration Pattern Under Bit-Rock Interaction
Shiyou jixie, 2023 Stick-slip vibration leads to high-frequency shear stress on drill string and premature fatigue of drill string.Therefor,the torsional vibration model of drill string system considering bit-rock interaction was built by coupling the bit-rock interaction ...
Xing Xuesong +4 more
doaj
Control based bifurcation analysis for experiments [PDF]
, 2008 We introduce a method for tracking nonlinear oscillations and their bifurcations in nonlinear dynamical systems. Our method does not require a mathematical model of the dynamical system nor the ability to set its initial conditions.
Krauskopf, B., Sieber, J.
core +1 more source
Stick–slip vibrations in oil well drillstring: A review
Journal of Low Frequency Noise, Vibration and Active Control, 2020 A survey of the literature related to theoretical and experimental studies on stick–slip vibration in oilwell drillstring is carried out in this study. It aims to explain key concepts and present the existing methods for studying this phenomenon.
Liping Tang +4 more
doaj +1 more source