Results 21 to 30 of about 48,906 (308)
Detonation Induced Strain in Tubes [PDF]
, 2010 When a detonation wave propagates through a piping system, it acts as a traveling pressure load to the pipe wall. The detonation wave must be followed by an expansion wave in order to bring the combustion products to zero velocity at the ignition end ...
Karnesky, James Alan
core +1 more source
Journal of Materials Research and Technology, 2022 The objective of this research is to systematically understand how strain-hardening models and phase- and temperature-dependent strain-hardening slopes affect the computed residual stresses in single-pass welded joints made of the widely used structural ...
Jiamin Sun +2 more
doaj +1 more source
New Stress-Strain Model for Identifying Plastic Deformation Behavior of Sheet Materials [PDF]
한국정밀공학회지, 2017 In sheet metal forming numerical analysis, the strain hardening equation has a significant effect on calculation results, especially in the field of spring-back. This study introduces the Kim-Tuan strain hardening model.
Young Suk Kim +2 more
doaj +1 more source
Evaluation on Flexibility of Phenomenological Hardening Law for Automotive Sheet Metals
Metals, 2022 Constitutive modeling of sheet metals involves building a system of equations governing the material behavior under multi-axial stress states. In general, these equations require a hardening law that describes the stress-strain relationship.
Quoc Tuan Pham, Young-Suk Kim
doaj +1 more source
Effect of Heat Treatment on the Strain Hardening Behaviour of an Al-Si-Cu Alloy [PDF]
Archives of Foundry EngineeringThis study investigates the mechanical behaviour of the AlSi9Cu1 alloy after T6 heat treatment, with a focus on its strain hardening response. Uniaxial tensile tests were conducted on heat-treated specimens to determine the strain hardening exponent n ...
M. Frátrik, E. Kantoríková
doaj +1 more source
Journal of Materials Research and Technology, 2022 Lean duplex stainless steels (LDSS) have a microstructure composed of ferrite and austenite phases. This microstructure provides good mechanical and corrosion resistances.
Renata Mangini Santos +3 more
doaj +1 more source
Metalurgija, 2021 The present work is aimed at studying the macroscopic localization of plastic strain in low-carbon steel AISI A283 Grade C. The evolution of macroscopically localized plastic strain at various stages of strain hardening is visualized via a Digital image ...
Yu. Li, S. Barannikova
doaj
Frontiers in Mechanical Engineering, 2020 Indentation measurements are a crucial technique for measuring mechanical properties. Although several contact models have been developed to relate force-displacement measurements with the mechanical properties, they all consider simplifying assumptions,
Hamid Ghaednia +4 more
doaj +1 more source
Journal of Materials Research and Technology, 2022 The present work develops a new constitutive equation model for strain-hardening behavior of metallic materials (named herein as the Gonoring model) based on the definition of the instantaneous strain-hardening exponent.
Tiago Bristt Gonoring +4 more
doaj +1 more source
Experimental study of tensile response of Strain Hardening UHPFRC at early age [PDF]
, 2017 Strain Hardening Ultra High Performance Fibre Reinforced Concrete (SH-UHPFRC), has a high tensile strength (over 10 MPa) and exhibit significant strain hardening (several ‰) under tensile loads.
Mohamed A. Hafiz +3 more
core +1 more source