Results 211 to 220 of about 2,821,004 (350)

Clinical Relevance of Left Atrial Early Diastolic Strain Rate as a Predictor of Left Atrial Remodeling Following Mitral Valve Repair. [PDF]

Circ Rep
Hidaka H, Usuku H, Noguchi M, Uchikura K, Nishiguchi H, Hirota T, Horibe T, Takaki J, Yoshinaga T, Fukui T.   +9 more
europepmc   +1 more source

Experimental and numerical investigation of the strain rate-dependent compression behaviour of a carbon-epoxy structure

, 2017
Tobias Schmack, T.M. Morgado Martins Filipe, Günter Deinzer, Christos Kassapoglou, Frank Walther   +4 more
openalex   +2 more sources

Fabrication of Multifunctional FeSi Gyroid Lattice Composites via Additive Manufacturing and Polymer Infiltration

Advanced Engineering Materials, EarlyView.
A two‐step approach combining laser powder bed fusion of FeSi electrical steel with Bakelite infiltration enables the fabrication of multifunctional gyroid lattice composites. The resulting structures exhibit high strength, magnetic anisotropy, and complete polymer infiltration, demonstrating a simple and scalable route toward lightweight, mechanically
Angelo F. Andreoli, Mayumi A. Nakahashi, Vitor E. Pinotti, Felipe O. C. Bernardo, Lidiane C. Costa, Francisco G. Coury, Ronei C. de Oliveira, Adilson J. A. de Oliveira, Carlos E. H. Ventura, Piter Gargarella   +9 more
wiley   +1 more source

Self-consistent hardness measurements spanning eleven decades of strain rate on a single material surface. [PDF]

Nat Commun
Borasi L, Schuh CA.
europepmc   +1 more source

Four‐Point Bending Tests at High Temperatures on Commercial MgO‐C Refractory Bricks with and Without Recyclate Considering Different Carbon Contents

Advanced Engineering Materials, EarlyView.
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm, Lukas Knöchel, Thomas Schemmel, Christos G. Aneziris, Anja Weidner, Horst Biermann   +5 more
wiley   +1 more source

A comparative analysis of myocardial strain and strain rate in cardiac computed tomography and magnetic resonance feature tracking. [PDF]

Radiol Med
Del-Canto I, López-Lereu MP, Monmeneu JV, Maceira A, Moratal D.   +4 more
europepmc   +1 more source

Deformation of Copper Single Crystals and Polycrystals at High Strain Rates

, 1967
Norio Nagata, Susumu Yoshida
openalex   +2 more sources

Deformation Twinning in Polycrystalline Mg Microstructures at High Strain Rates at the Atomic Scales [PDF]

, 2019
Garvit Agarwal, Avinash M. Dongare
openalex   +1 more source

Engineering Deformation and Failure in Diamond Triply Periodic Minimal Surface Lattices via 3D Wall‐Thickness Grading

Advanced Engineering Materials, EarlyView.
The work demonstrates that strategic wall‐thickness grading in diamond triply periodic minimal surface lattices enables precise tuning of deformation and failure behavior under compression. Different gradation patterns guide how and where the structure collapses, improving energy absorption or promoting controlled brittle failure.
Giovanni Rizza, Danilo Bruson, Manuela Galati, Luca Iuliano   +3 more
wiley   +1 more source

Infection of a French Population of Aedes albopictus and of Aedes aegypti (Paea Strain) with Zika Virus Reveals Low Transmission Rates to These Vectors’ Saliva [PDF]

, 2017
Faustine Ryckebusch, Michèle Berthet, Dorothée Missé, Valérie Choumet   +3 more
openalex   +1 more source