Results 111 to 120 of about 483,350 (311)
Harnessing Fungal Biowelding for Constructing Mycelium‐Engineered Materials
Advanced Engineering Materials, EarlyView.Mycelium‐bound composites (MBCs) offer low‐carbon alternatives for construction, yet interfacial bonding remains a critical challenge. This review examines fungal biowelding as a biocompatible adhesive, elucidating mycelium‐mediated interfacial mechanisms and their role in material assembly. Strategies to optimize biowelding are discussed, highlighting
Xue Brenda Bai +2 more
wiley +1 more source
Characterizing the true stress-strain curve of CrAlN coatings by nanoindentation using finite element-reverse analysis [PDF]
MATEC Web of ConferencesThis paper proposes a methodology to convert thin film nanoindentation load-displacement curves into tensile stress-strain curves. An optimization procedure, based on the trust-region reflective algorithm, is established to identify a unique set of three
Ben Ammar Yamen +4 more
doaj +1 more source
Prediction of Stress-Strain Curves for HFRP Composite Confined Brick Aggregate Concrete under Axial Load. [PDF]
Polymers (Basel), 2023 Saingam P +6 more
europepmc +1 more source
Nonlinear analysis of laminated fibrous composites [PDF]
A computerized analysis of the nonlinear behavior of fibrous composite laminates including axial loading, thermal loading, temperature dependent properties, and edge effects is presented.
Herakovich, C. T., Renieri, G. D.
core +1 more source
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Analysis and Modeling of Stress-Strain Curves in Microalloyed Steels Based on a Dislocation Density Evolution Model. [PDF]
Materials (Basel), 2022 Sobotka E +3 more
europepmc +1 more source
Inuence of Foam Filling on Dynamic Response of Hemispherical Shell Subjected to Blast Pressure. [PDF]
, 2013 The paper aims to investigate the effect of aluminium foam filling of hemispherical steel shell on its dynamic response, accounting for the blast pressure modelling. The considered structures subjected to uniformly distributed pressure, rigidly connected
Kowal-Michalska, Katarzyna +2 more
core
AbstractTraditionally, stress strain curves for example from tensile testing are described with empirical models with a number of adjustable parameters such as Hollomon, Ludwik, Voce and Swift. With such models it is difficult or impossible to generalize and extrapolate.
openaire +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Dynamic Recrystallization Behavior and Critical Conditions of SiCp/A1-Cu Composite
Journal of Aeronautical Materials, 2017 Using the Gleeble-1500D simulator, the high temperature plastic deformation behavior of 40%SiCP/Al-Cu composite were investigated at 350-500℃ with the strain rate of 0.01-10 s-1. The stress-strain curves were obtained during the tests.
HAO Shiming +4 more
doaj +1 more source