Results 1 to 10 of about 916,715 (181)
Stress and deformation characteristics of sea ice in a high-resolution, anisotropic sea ice model. [PDF]
Philos Trans A Math Phys Eng Sci, 2018 The drift and deformation of sea ice floating on the polar oceans is caused by the applied wind and ocean currents. Over ocean basin length scales the internal stresses and boundary conditions of the sea ice pack result in observable deformation patterns.
Heorton HDBS, Feltham DL, Tsamados M.
europepmc +2 more sources
NUMERICAL WELLBORE STABILITY FOR VERTICAL AND DEVIATED WELLS USING FINITE ELEMENT METHOD [PDF]
Romanian Journal of Petroleum & Gas Technology, 2022 A 3D vertical wellbore model is created in this paper using the ANSYS finite-element software package to examine stress distribution contours and displacement plots, and then developing a comprehensive approach for converting the vertical model into any ...
Mohamed Halafawi +2 more
doaj +1 more source
Investigation of Roller Press Surface and Stud Based on FEM Simulation
Applied Sciences, 2023 As an emerging grinding equipment, roller presses are widely used in Cement industry. The current problem with roller press is that the rolls surface is prone to wear and needs to be replaced regularly. This greatly reduces the service life of the roller
Fulin Wang, Jin Du, Guosheng Su
doaj +1 more source
Investigation and Analysis of Stress and Deformation Monitoring of Long-Span Steel Roof Trusses
Buildings, 2023 Structural stress and deformation monitoring and analysis were carried out for the 54 m long-span steel roof truss. To ensure the safety of the construction process, the stress and deformation of the steel roof trusses were monitored throughout the ...
Cun Hui +3 more
doaj +1 more source
Advances in Materials Science and Engineering, 2023 The stress and deformation response characteristics of the support structure in the process of excavation and support of circular sand foundation pit are complex.
Xuhe Gao +5 more
semanticscholar +1 more source
Journal of Materials Research and Technology, 2021 Thin-walled pipes have been widely used in chemical facilities and propulsion structures, where the distortion problem induced by welding fabrication is common and prominent, deteriorating assembly accuracy and even reducing load-bearing capacity ...
Yong Liu, Ping Wang, H. Fang, N. Ma
semanticscholar +1 more source
Yantu gongcheng xuebao, 2023 The in-situ tests on the single-layer lining structure for water conveyance tunnels in South China are carried out, the mechanical response of the structure under the internal pressure in the surrounding rock is revealed, and the influences of different ...
MO Jianhao 1, TANG Xinwei 1, YAN Zhenrui 2
doaj +1 more source
Journal of Marine Science and Engineering, 2023 Calcareous sand is a special marine soil rich in calcium carbonate minerals, characterized by brittle particles. It is, therefore, widely used as a filling material in the construction of islands and reefs.
Kangyu Wang +4 more
semanticscholar +1 more source
Deformation and Stress Analysis of Pile-Supported Immersed Tunnels under Seismic Loads
Applied Sciences, 2023 The stress and deformation of pile-supported immersed tunnels under seismic loads is a critical issue in tunnel design. This paper utilizes ABAQUS (version 2020) finite element software to analyze the seismic load response of the sand compaction pile ...
Yan Zhuang, Hu Fan, Shunlei Hu, Zhi Chen
doaj +1 more source
IET Electric Power Applications, 2022 The noise and vibration level in modular‐type permanent magnet synchronous machines with fractional slot concentrated windings (FSCW) is considered to be an important design consideration, particularly for applications requiring fault tolerance.
Sayyed Haleem Shah +4 more
doaj +1 more source