Results 151 to 160 of about 3,086,724 (203)
Some of the next articles are maybe not open access.
Characterisation of stress corrosion cracking (SCC) of Mg–Al alloys
Materials Science & Engineering A: Structural Materials: Properties, Microstructure and Processing, 2008Stress corrosion cracking (SCC) of the Mg-Al alloys AZ91, AZ31 and AM30 in distilled water has been characterised using constant extension rate tests (CERTs) and linearly increasing stress tests (LISTs). AZ91 consists of an α-matrix with extensive β-particles, whereas AZ31 and AM30 consist only of an α-matrix with an Al-concentration similar to that in
Guang-Ling Song +2 more
exaly +6 more sources
Stress corrosion cracking (SCC) of aluminium alloys
, 2011 The stress corrosion cracking (SCC) behaviour of aluminium alloys has been studied for the past five decades and is still a research area of high interest due to the demand for higher strength aluminium alloys for fuel saving. This chapter brings out the general understanding of the SCC mechanism(s) and the critical metallurgical issues affecting the ...
Kannan, M. Bobby +2 more
core +3 more sources
A Critical Review of the Stress Corrosion Cracking (SCC) of Magnesium Alloys
Advanced Engineering Materials, 2005AbstractThis review aims to provide a foundation for the safe and effective use of magnesium (Mg) alloys, including practical guidelines for the service use of Mg alloys in the atmosphere and/or in contact with aqueous solutions. This is to provide support for the rapidly increasing use of Mg in industrial applications, particularly in the automobile ...
Norbert Hort +2 more
exaly +5 more sources
Stress corrosion cracking (SCC) of magnesium (Mg) alloys
, 2011 This chapter reviews current research into stress corrosion cracking (SCC) in magnesium (Mg) alloys, particularly intergranular stress corrosion cracking (IGSCC) and transgranular stress corrosion cracking (TGSCC). A nearly continuous second phase along grain boundaries causes IGSCC.
Atrens, A. +4 more
openaire +3 more sources
Metallurgical factors in stress corrosion cracking (SCC) and hydrogen-induced cracking (HIC)
Journal of Solid State Electrochemistry, 2009Nonmetallic inclusions can affect resistance of steels to both general and localized corrosion, including pitting corrosion, stress corrosion cracking (SCC), and hydrogen-induced cracking (HIC). Because stress corrosion cracks frequently initiate at pits, and pits nucleate at sulfides, the presence of sulfides is likely to affect the SCC process ...
R W Revie
exaly +2 more sources
Understanding and Modeling of Stress Corrosion Cracking (SCC)
Key Engineering Materials, 2010 Stress corrosion cracking (SCC) is a brittle fracture of a ductile material under severe environment. Due to the complexity of mechano-chemical degradation during SCC formation, the scientific community is still far from the complete understanding of this phenomenon.
Byoung Ho Choi, Alexander Chudnovsky
openaire +2 more sources
SCC (Stress Corrosion Cracking) Behaviors of Mg-7Al Alloy
Materials Science Forum, 2010Stress corrosion cracking (SCC) behaviors of Mg-7Al-0.3Mn alloy in 0.21M K2CrO4+0.6M NaCl solution and in air were studied using slow strain rate test (SSRT). The effect of electrode potential on SCC behaviors of the alloy was investigated in 0.21M K2CrO4+0.6M NaCl solution during SSRT.
Ya Zhang +3 more
exaly +2 more sources
Stress corrosion cracking (SCC) failure in marine areas of fixed guards for climbing
Corrosion Engineering, Science and Technology, 2014 This work studies the particular mechanism of environmental stress corrosion cracking (SCC) that has been described to interest stainless steel products, like climbing anchors, installed in sea are ...
Deflorian, Flavio +4 more
openaire +3 more sources
Low Level Corrosion as an Indicator of Stress Corrosion Cracking (SCC)
CORROSION 2004, 2004Abstract Whenever stress corrosion cracking (SCC) is found on buried pipelines it is usually found in areas with disbonded polyethylene (P.E.) coatings. Interpretation of metal loss in-line inspection (ILI) logs can indicate areas that appear to be low-level metal loss similar to corrosion found under disbonded coatings.
Steve Waker, Gabriela Rosea, Mike Hylton
openaire +1 more source