Results 11 to 20 of about 3,086,724 (203)
Pressure effects on the hot-salt stress-corrosion cracking of titanium alloys [PDF]
, 1994 Benefiting from good specific mechanical properties, exceptional oxidation resistance, and high temperature capability, Titanium Alloys are used in Gas Turbine Engines, especially in the early stages of the compressor.
Chevrot, Thierry, Chevrot, T
core +7 more sources
A multiscale constitutive model for intergranular stress corrosion cracking in type 304 austenitic stainless steel [PDF]
, 2013 Intergranular stress corrosion cracking (IGSCC) is a fracture mechanism in sensitised austenitic stainless steels exposed to critical environments where the intergranular cracks extends along the network of connected susceptible grain boundaries.
Rahimi, S +4 more
core +4 more sources
A study of crack initiation in corrosion-fatigue of A.I.S.I 316 stainless steel by dynamic measurement of corrosion characteristics and corrosion current transients [PDF]
, 1980 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.A technique has been developed and applied to monitor corrosion current transients, in phase with a cyclic stress.
Martin, JW
core +7 more sources
Influence of oxide films on primary water stress corrosion cracking initiation of alloy 600 [PDF]
, 2006 In the present study alloy 600 was tested in simulated pressurised water reactor (PWR) primary water, at 360 °C, under an hydrogen partial pressure of 30 kPa. These testing conditions correspond to the maximum sensitivity of alloy 600 to crack initiation.
Panter, J. +6 more
core +1 more source
Metals, 2023 Despite the high corrosion resistance of austenitic stainless steels (SSs), a significant reduction of stress corrosion cracking (SCC) resistance has been reported in cases of high residual stress and metastable microstructural features.
Ji Ho Shin
doaj +1 more source
Results in Physics, 2016 The stress corrosion cracking (SCC) behavior of AISI347 austenitic stainless steel exposed to acid solution containing chloride ion at different temperature and pressure is studied through slow strain rate testing (SSRT) at different test condition.
Yanpeng Qu +3 more
doaj +1 more source
Journal of Materials Research and Technology, 2022 The propagation behavior of stress corrosion cracking (SCC) for two CrNiMoV steels in the simulated environment of low-pressure nuclear steam turbine rotor was systematically investigated by microstructural characterizations, electrochemical measurements,
Shuo Weng +3 more
doaj +1 more source
Nuclear Engineering and Technology, 2019 Stress corrosion cracking (SCC) widely found in both primary and secondary sides of steam generator (SG) tubing in pressurized water reactors (PWR) has become an important safety issue.
Tae Hyun Lee +6 more
doaj +1 more source
Materials & Design, 2019 The corrosion behavior of Al-Zn-Mg-Cu alloy on different Cu content and quench rate has been investigated by inter-granular corrosion (IGC), exfoliation corrosion (EXCO), and stress corrosion cracking (SCC) test, and combined with scanning electron ...
Dingling Yuan +6 more
doaj +1 more source
Role of Environmental Chemistry in Governing the Corrosion and Stress Corrosion Cracking Mechanism of L415 Pipeline Steel in Acidic Soils. [PDF]
Materials (Basel)The operational integrity of L415 pipeline steel, a critical component of China’s energy network, is severely threatened by the unique acidic red soil environments prevalent in Southern China.
Liu S +6 more
europepmc +2 more sources