Results 31 to 40 of about 8,893 (213)

Assessment of mechanical properties and microstructure characterizing techniques in their ability to quantify amount of cold work in 316l alloy [PDF]

, 2020
Stress corrosion cracking (SCC) behavior is a matter of concern for structural materials, namely, stainless steels and nickel alloys, in nuclear power plants.
Hamelin, C, Hill, MR, Linke, BS, Muránsky, O, Smith, H   +4 more
core  

Analisis Stress Corrosion Cracking (Scc) Tembaga Dengan Variasi Pembebanan Pada Media Korosi Air [PDF]

, 2014
Pengujian Stress Corrosion Cracking (SCC) dilakukan untuk mengetahui korosi retak tegang pada logam akibat gabungan antara tegangan tarik statik dengan lingkungan korosif. Pada pengujian ini menggunakan benda uji tembaga.
Bayuseno, A. P. (Athanasius), Setyarso, E. A. (Erizal)   +1 more
core   +1 more source

Stress corrosion cracking behavior of X80 pipeline steel under alternating current, Desulfovibrio desulfurican and cathodic protection potential

Journal of Materials Research and Technology, 2023
The stress corrosion cracking (SCC) behavior of X80 pipeline steel under Desulfovibrio desulfurican (D. desulfurican), alternating current (AC) and cathodic protection (CP) was studied by the constant load tests and slow strain rate tensile (SSRT) test ...
Qi Fu, Qingyu Qin, Boxin Wei, Jin Xu, Changkun Yu, Cheng Sun   +5 more
doaj   +1 more source

Study on Stress Corrosion Cracking Sensitivity of Super 13Cr Martensitic Stainless Steel in Chloride-Containing Completion Fluids [PDF]

Cailiao Baohu
During oil extraction，the corrosion of oil pipes caused by chloride-containing completion fluids has been a hot research topic.To address this problem， the stress corrosion cracking (SCC) sensitivity of Super 13Cr stainless steel was investigated under ...
LI Jun, YU Yanzhao, ZHU Hongzhang, YU Xiaohong, LEI Bo, CHEN Changfeng
doaj   +1 more source

Environmental protection of titanium alloys in centrifugal compressors at 500°C in saline atmosphere [PDF]

, 2004
The use of the titanium alloy Ti-6246 (Ti–6Al–2Sn–4Zr–6Mo, wt-%) for gas turbine compressors allows an increase in working temperature and stress level.
BEGUIN J. D., D. Adrian, D. Fournier, ENCRENAZ M., GARFINKLE M., J. Alexis, J.A. Petit, J.D. Beguin, P. Belaygue, P. Faure, TRAVKIN V. V.   +10 more
core   +3 more sources

Stress Corrosion Cracking of Steel and Aluminum in Sodium Hydroxide: Field Failure and Laboratory Test

Advances in Materials Science and Engineering, 2012
Through an investigation of the field failure analysis and laboratory experiment, a study on (stress corrosion cracking) SCC behavior of steel and aluminum was performed. All samples were extracted from known operating conditions from the field failures.
Y. Prawoto, K. Sumeru, W. B. Wan Nik
doaj   +1 more source

Properties of protective oxide scales containing cerium on Incoloy 800H in oxidizing and sulfidizing environments. I. Constant-extension-rate study of mechanical properties [PDF]

, 1988
The mechanical properties of ceramic coatings containing cerium oxide, prepared by the sol-gel method and used to protect Incoloy 800H against aggressive environments, are reported.
Fransen, T., Geerdink, B., Gellings, P.J., Haanappel, V.A.C.   +3 more
core   +2 more sources

Tensile Stress Induced by Aluminum Corrosion [PDF]

, 2012
Stress corrosion cracking (SCC) is a critical problem affecting the safety and viability of both existing energy conversion systems and ones under consideration for future development.
Hebert, Kurt, Hebert, Kurt R, Shrotriya, Pranav, Shrotriya, Pranav, Stafford, Gery, Çapraz, Ömer, Çapraz, Ömer   +6 more
core   +2 more sources

Influence of oxide films on primary water stress corrosion cracking initiation of alloy 600 [PDF]

, 2006
In the present study alloy 600 was tested in simulated pressurised water reactor (PWR) primary water, at 360 °C, under an hydrogen partial pressure of 30 kPa. These testing conditions correspond to the maximum sensitivity of alloy 600 to crack initiation.
Andrieu, Eric, Cloué, Jean-Marc, Combrade, P., Foucault, M., Panter, J., Viguier, Bernard   +5 more
core   +2 more sources

Environmentally assisted stress corrosion cracking behaviour of low alloy steel in SO2-containing NaCl solution

Journal of Materials Research and Technology, 2022
The environmentally assisted stress corrosion cracking (SCC) behaviours of low alloy E690 steel in SO2-containing NaCl solution are investigated. The result shows that the corrosion on the metal surface becomes serious with the addition of NaHSO3, which ...
Yuntao Xin, Kun Song, Yong Li, Endian Fan, Xuewei Lv   +4 more
doaj   +1 more source