Results 21 to 30 of about 34,487 (218)
Here, we demonstrate that HS1BP3 interacts with Cortactin through a proline‐rich region (PRR3.1) and show that this interaction, and HS1BP3 itself, promote cancer cell proliferation and invasion. Inhibition of this interaction leads to build‐up of TKS5 in multivesicular endosomes and altered secretion of CD63 and CD9, providing an explanation for the ...
Arja Arnesen Løchen +9 more
wiley +1 more source
We have developed a mathematical model to study the boundary layer flow of a Casson-Maxwell fluid over vertical stretching surfaces. We considered the induced magnetic field, which affected the coupled stress tensor.
Nadeem Abbas +3 more
doaj +1 more source
A boundary layer analysis is carried out to study the influences of second order slip, viscous and Ohmic dissipations on steady two dimensional, incompressible flow of water based nanofluid over a stretching/stretching sheet embedded in a thermally ...
N. Vishnu Ganesh +2 more
doaj +1 more source
Raman‐based label‐free microscopic analysis of the pancreas in living zebrafish larvae
Forward stimulated Raman scattering (F‐SRS) and epi coherent anti‐Stokes Raman scattering (E‐CARS) allow label‐free discrimination of distinct subcellular structures in the pancreas of living zebrafish larvae. Given the straightforward applicability, we anticipate broad implementation of Raman microscopy in other organs and across various biomedical ...
Noura Faraj +3 more
wiley +1 more source
The present work discusses the laminar boundary layer flow of an electrically conducting Casson fluid due to a horizontal perforated sheet undergoing linear shrinking/stretching with mass transpiration.
Jitender Singh +3 more
doaj +1 more source
This study presents a reversible temperature sensor with high switching ratio, ∼103. The device is fabricated using PET‐ITO and carbon nanotube dispersions in alkane. Considering its application in cold chain logistics, a proof‐of‐concept with LED is showcased. Thus, a temperature drop below the threshold temperature (crystallization temperature of the
Sunil Kumar Behera +8 more
wiley +1 more source
A flexure‐based variable stiffness structure is developed by integrating phase‐change modulation and adhesive interfacial locking of gallium. The design enables a wide stiffness variability, transitioning from soft, flexible behavior to rigid, load‐supporting performance.
Sungjin Kim +2 more
wiley +1 more source
During the two-pass stretch forming process for manufacturing of thin-walled aluminum alloy sheet components, abnormal grain growth may happen if an improper pre-deformation degree was conducted before solution heat treatment, which is negative to the ...
Lihui An, Jiguang Li, Shijian Yuan
doaj +1 more source
Mg–Zn composites with a thickness of 0.21 mm were fabricated using roll bonding of a kirigami‐patterned Mg alloy inlay within a Zn matrix. Thermal activation following this process led to the formation of tailored intermetallic structures, which provided the composite with enhanced flexural strength.
Yaroslav Frolov +4 more
wiley +1 more source
Radiative flow of hyperbolic tangent liquid subject to Joule heating
Influence of thermal radiation in MHD stagnation point flow towards an exponentially stretching sheet is studied. Constitutive relation for an incompressible hyperbolic tangent liquid is taken into account.
T. Hayat +3 more
doaj +1 more source

