Results 111 to 120 of about 12,560 (233)

Pengaruh Panjang Penyaluran Terhadap Kuat Cabut Tulangan Baja [PDF]

, 2010
Salah satu persyaratan dalam perancangan beton bertulang yang harus diperhatikan adalah panjangpenyaluran tulangan. Panjang penyaluran adalah panjang penambatan yang diperlukan untukmengembangkan tegangan luluh pada tulangan yang merupakan fungsi dari ...
Ginting, A. (Arusmalem), Purnomo, T. W. (Tri)   +1 more
core  

Strut-and-Tie Models of Masonry Shear Walls

, 2018
This paper contains theoretical fundamentals of strut and tie models, used in unreinforced horizontal shear walls. Depending on support conditions and wall loading, we can distinguish models with discrete bars when point load is applied to the wall (type I model) or with continuous bars (type II model) when load is uniformly distributed at the wall ...
openaire   +2 more sources

Behavior predictions of deep beams with short straight bar anchorages using strut-and-tie models and nonlinear analysis

Revista IBRACON de Estruturas e Materiais
This paper investigates the laboratory test results of 12 deep beams available in the literature, where the longitudinal reinforcement was anchored into the support using short straight bar anchorages.
R. A. SOUZA, S. BREÑA
doaj   +1 more source

Optimal strut-and-tie modelsi n reinforced concrete structures

Computer Assisted Methods in Engineering and Science, 2023
A general solution of the diffusion problems which concern the R.C. structures, may be deduced by the limit analysis, by means of truss schemes suitable to model the load transfer mechanism.
Fabio Biondini, Franco Bontempi, Pier Giorgio Malerba   +2 more
doaj  

A Note on the Calculation of Supercavitating Hydrfoils with Rounded Noses [PDF]

, 1973
Practical supercavitating hydrfoils have rounded leading edges for mechanical strength. The prediction of pressures near the leading edge of such hydrofoils by linearized free streamline theory fails because singularities are usually required there by ...
Acosta, A. J., Furuya, O.
core  

Development of deployable structures for large space platform systems, part 1 [PDF]

Eight deployable platform design objectives were established: autodeploy/retract; fully integrated utilities; configuration variability; versatile payload and subsystem interfaces; structural and packing efficiency; 1986 technology readiness; minimum EVA/
Cox, R. L., Nelson, R. A.
core   +1 more source

Reinforced Concrete Corbels – State of the Art. [PDF]

, 2016
This paper represents a historical review, state-of-the-art review, on the experimental researches carried out on corbels in general and strengthening of corbels in particular.
Bachi, Eyad kadhem Sayhood, Hasan, Qais Abdul Mageed, Yassin, Layla Ali Ghalib   +2 more
core   +1 more source

Spartan Daily, December 1, 1953 [PDF]

, 1952
Volume 42, Issue 46https://scholarworks.sjsu.edu/spartandaily/11949/thumbnail ...
San Jose State University, School of Journalism and Mass Communications
core   +2 more sources

The influence of connecting pile cap-column in the mechanisms of break in the two pile caps

Revista IBRACON de Estruturas e Materiais
The paper analyzes the two pile caps with partially embedded socket and subject a center load. Three models were experimentally tested, varying the type of conformation of the column and walls of the socket, with a smooth, the other rough, and a ...
A. C. MESQUITA, A. S. ROCHA, R. G. DELALIBERA, W. A. DA SILVA   +3 more
doaj   +1 more source

Strut and tie models for analysis/design of external beam-column joints [PDF]

, 2001
Newman,J.B.,, Vollum,R.L.,
core   +1 more source