Results 41 to 50 of about 4,973 (210)
Abstract This paper is concerned with the development of an analytical model to determine the subcooled boiling characteristics under forced convective conditions over a wide range of mass flows and subcoolings. This model considers the two regions of subcooled boiling: local boiling with stationary bubbles (high subcooling), and local boiling with ...
Sami, S.M., Duong, T.
openaire +1 more source
Enhanced Roofs for Passive Building Design: A Systematic Review of Thermal and Energy Performance
This systematic review evaluates PCM‐ and NePCM‐integrated roofing systems for passive cooling. PCM roofs reduce heat flux and indoor temperature fluctuations, while NePCMs improve thermal conductivity with latent heat trade‐offs. Hybrid cooling strategies enhance performance, and future challenges in scalability, durability, and practical ...
Peerzada Jaffar Abass, Mohammed Ibrahim
wiley +1 more source
Experimental and Numerical Study of Film Boiling Around a Small Nickel Sphere
This work—mixing an original experimental approach, as well as numerical simulations—proposes to study film boiling modes around a small nickel sphere. While dealing with a simple looking phenomenon that is found in many industrial processes and has been
Charles Brissot +4 more
doaj +1 more source
Heat Transfer Enhancement in the Microscale: Optimization of Fluid Flow
Microscale heat transfer deviates from conventional behavior due to scale effects and fluid properties. This review examines single‐phase convection and advanced working fluids, highlighting key mechanisms such as rarefaction, surface effects, and phase interactions, to guide optimized design of high‐performance microchannel heat exchangers.
Md Atiqur Rahman +6 more
wiley +1 more source
Engineered activated carbon materials with tailored pore structures and surface chemistry deliver high‐performance dual functionality across supercapacitors and hydrogen storage, establishing clear structure–property–performance relationships that advance scalable carbon‐based solutions for next‐generation energy storage and conversion.
Rayhan Hasan Pranto +4 more
wiley +1 more source
Coalescence-induced jumping of condensate droplets has been studied as an emerging mode for enhanced condensation heat transfer. However, the spontaneous droplet jumping phenomenon usually disappears at relatively higher degrees of subcooling due to the ...
Lin-Wei Mou +4 more
doaj +1 more source
Two‐phase ammonia plume behavior in a still room: Jack Rabbit III chamber studies
Abstract This paper describes a new set of 45 laboratory experiments where about 180 g of ammonia was released from pressurized liquefied storage in a still 51.3 m3 chamber (i.e., a small room) and the variations of the ammonia gas concentrations and liquid deposition over a 60 min time period were investigated.
Steven Hanna +2 more
wiley +1 more source
Is subcooling the right driving force for testing low-dosage hydrate inhibitors?
The degree of subcooling is usually used as the driving force for hydrate formation; however, it does not encompass the effect of pressure. A comprehensive driving force for hydrate formation is a function of pressure, temperature, and gas composition ...
Danesh, Ali +3 more
core +1 more source
Assessment of the subcooling capabilities of a thermoelectric device in a vapor compression refrigeration system [PDF]
The paper presents some theoretical results regarding the subcooling capabilities of a thermoelectric device. The refrigeration system taken into account uses the R-134a refrigerant; a constant refrigerant flow of 1.4 m3/h was considered for all ...
Țenu, Ioan +4 more
core +1 more source
Assessment of Hydrate Prediction Software for MEG–Water–NaCl Systems
ABSTRACT This study evaluates the performance of three industry‐standard simulation tools—Aspen HYSYS (V14), Multiflash (V7.5), and OLGA (V2024.1)—by comparing predicted hydrate dissociation temperatures with experimental data obtained from a PVT sapphire cell.
Carys M. Bloomfield +2 more
wiley +1 more source

