Results 61 to 70 of about 27,185 (266)
Synthesis of AgBiS2 and AgInS2 Based on Formation Energies in Sulfur‐Rich Reducing Flame
High‐surface‐area AgInS2 and AgBiS2 nanoparticles were synthesized via enclosed flame spray pyrolysis by tuning flame conditions and formation energies to guide phase formation. Flame parameters were tuned to suppress oxides and enable pure sulfide phase growth.
Muhammad Ali Martuza +7 more
wiley +1 more source
Conversion of boiler houses to alternative fuel
THE PURPOSE. To justify the need to transfer boiler houses from fuel oil to furnace domestic fuel. METHODS. Comparative studies of the main indicators of the quality of fuel oil and domestic heating oil (DHO) (heat of combustion, kinematic viscosity ...
E. N. Makeeva +2 more
doaj +1 more source
Surface‐host dialogue at the implant interface governs biological fate and osseointegration. Surface physicochemical properties of titanium (Ti) dental implants, including microgrooves, nanopatterns, nanotopography, roughness, and wettability, modulate the initial adsorption of proteins and the formation of a dynamic biointerface.
Daniela Moreira Cunha +9 more
wiley +1 more source
PURIFICATION OF THE HEAT-ELECTRIC GENERATING STATION FLUE GASES OF SULFUR AND NITROGEN OXIDES
Technological schema of furnace gases cleaning of ash and sulfur and nitric oxides, allowing to reach maximum degree of cleaning at minimum costs, is ...
V. A. Arbuzov +3 more
doaj
INCOMPLETE COAL COMBUSTION AND FACTORS THAT INFLUENCE THE CONTENT OF UNBURNED CARBON IN BOTTOM ASH. EFFECTS OF INCOMPLETE COMBUSTION ON THE OPERATION OF THE WET FGD SYSTEM - A CASE STUDY [PDF]
Sulphur oxide removal from flue gas is a legal requirement for any large capacity combustion equipment. The paper presents the case of thermal power plant Rovinari (Romania), where Wet Flue Gas Desulfurization with limestone slurry has been implemented ...
Lucica Anghelescu +2 more
doaj
Metal‐free carbon catalysts enable the sustainable synthesis of hydrogen peroxide via two‐electron oxygen reduction; however, active site complexity continues to hinder reliable interpretation. This review critiques correlation‐based approaches and highlights the importance of orthogonal experimental designs, standardized catalyst passports ...
Dayu Zhu +3 more
wiley +1 more source
POM‐Based Water Splitting Catalyst Under Acid Conditions Driven by Its Assembly on Carbon Nanotubes
A newly‐engineered POM‐based electrocatalyst incorporating non‐innocent counter cations exhibits fast kinetics for either the OER or HER under strongly acidic conditions (1 m H2SO4), depending on whether it is assembled on carbon nanotubes (1@CNT) or physically mixed with them (1/CNT). In water‐splitting tests using a two‐electrode setup, these systems
Eugenia P. Quirós‐Díez +8 more
wiley +1 more source
A high‐capacity polyimide‐linked porous organic polymer (HAT‐PTO) incorporating numerous redox‐active centers is synthesized via a hydrothermal reaction, delivering a high theoretical capacity of 484 mAh g−1. In situ hybridization with carboxyl‐functionalized multiwalled carbon nanotubes enhances conductivity and stability, achieving 397 mAh g−1 at C ...
Arindam Mal +7 more
wiley +1 more source
Introduction: The main objective of this study was to determine total carbon monoxide, sulfur oxides, nitrogen oxides, volatile organic compounds (VOCs), PM10 and PM2.5 emitted to air by burning gasoline and diesel fuel in the city of Isfahan.
Amirreza Talaiekhozani, Zeinab Eskandari
doaj
The way to solve the sulfur conductive problem is the key to improve the performance of lithium sulfur battery. Nano oxides can not only improve sulfur electrode porosity, but also adsorb more sulphur, in addition play a catalytic role to oxidation ...
Xing Hua LIANG +3 more
doaj +1 more source

