Results 51 to 60 of about 265 (213)
Advanced Materials, EarlyView.This work develops bias‐triggered conductivity relaxation as a novel technique to study oxygen reactions in mixed ionic‐electronic conducting thin films by integrating electrochemical titration and electrical conductivity relaxation to achieve synchronous multi‐parameter characterization, providing simultaneous electronic, ionic, and extraordinarily ...
Alexander Stangl +4 more
wiley +1 more source
International Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering, 2015 Different types of distributed generation (DG) sources could be connected to the main power grid in order to improve the reliability of the power system, in a smart grid. The association of ac and dc distribution grid are assigned for the efficient connection of renewable power resources.
K. Sreedhar Kumar, J N Chandra Sekhar
openaire +1 more source
IEEE Access, 2018 To enhance the stability of a micro-grid under fault conditions, this paper proposes the coordination control of a superconducting magnetic energy storage (SMES), an active superconducting fault current limiter (SFCL), and distributed generation units ...
Lei Chen +8 more
doaj +1 more source
Comparative Analysis of Work Function Measurement Techniques Based on Scanning Probe Microscopy
Advanced Materials, EarlyView.Non‐contact scanning probe microscopy visualizes the surface topography based on surface electronic properties. The tunneling current, which defines the geometry of the tunnel–junction, has to overcome the effective surface work function barrier to reach the probe from the surface.
Daryoush Nosraty Alamdary +2 more
wiley +1 more source
X‐ray magnetic circular dichroism
Major Reference Works, Page 508-515., 2022 International Tables for Crystallography is the definitive resource and reference work for crystallography and structural science.
Each of the eight volumes in the series contains articles and tables of data relevant to crystallographic research and to applications of crystallographic methods in all sciences concerned with the ...
Gerrit van der Laan C. Chantler +2 more
wiley +1 more source
Jurnal Teknik ITS, 2015 Increas demand load and power capacity requirement at PT Pindo Deli then the short circuit current that occur will be greater. this can cause damage to electrical equipment located around the point of interrupting and resulting failure of the electrical ...
Yohanes Sabriant Widyo Utomo +1 more
doaj
IEEE AccessWith the continuous development of power grid, the high short-circuit threatens the stability of the power system. The short-circuit exceeds the disconnection capacity of the circuit breaker and has a negative impact on the integrity and stability of the
Duanjiao Li +9 more
doaj +1 more source
Advances in Condensed Matter Physics, 2017 Considering the rapid development of high temperature superconducting (HTS) materials, superconducting power applications have attracted more and more attention in the power industry, particularly for electrical systems including renewable energy.
Lei Chen +3 more
doaj +1 more source
Advanced Materials Technologies, EarlyView.The article overviews past and current efforts on caloric materials and systems, highlighting the contributions of Ames National Laboratory to the field. Solid‐state caloric heat pumping is an innovative method that can be implemented in a wide range of cooling and heating applications.
Agata Czernuszewicz +5 more
wiley +1 more source
Sustainable Materials Design With Multi‐Modal Artificial Intelligence
Advanced Science, EarlyView.Critical mineral scarcity, high embodied carbon, and persistent pollution from materials processing intensify the need for sustainable materials design. This review frames the problem as multi‐objective optimization under heterogeneous, high‐dimensional evidence and highlights multi‐modal AI as an enabling pathway.
Tianyi Xu +8 more
wiley +1 more source