Results 51 to 60 of about 278 (222)
Energies, 2021 Recently, in order to overcome the difficulties of interrupting fault currents in multi-terminal direct current systems (MTDC), studies combining a saturated iron-core type superconducting current limiter (SFCL) and a direct current circuit breaker (DCCB)
Jae-In Lee +5 more
doaj +1 more source
Phase Engineering of Nanomaterials (PEN): Evolution, Current Challenges, and Future Opportunities
Advanced Materials, EarlyView.This review summarizes the synthesis, phase transition, advanced characterization spanning ex situ to in situ and operando techniques, and diverse applications of phase engineering of nanomaterials (PEN). It further outlines key challenges and future opportunities, such as phase stability, architecture control, and artificial intelligence (AI)‐driven ...
Ye Chen +7 more
wiley +1 more source
Jurnal Teknik ITS, 2015 Increas demand load and power capacity requirement at PT Pindo Deli then the short circuit current that occur will be greater. this can cause damage to electrical equipment located around the point of interrupting and resulting failure of the electrical ...
Yohanes Sabriant Widyo Utomo +1 more
doaj
IEEE AccessWith the continuous development of power grid, the high short-circuit threatens the stability of the power system. The short-circuit exceeds the disconnection capacity of the circuit breaker and has a negative impact on the integrity and stability of the
Duanjiao Li +9 more
doaj +1 more source
Advances in Condensed Matter Physics, 2017 Considering the rapid development of high temperature superconducting (HTS) materials, superconducting power applications have attracted more and more attention in the power industry, particularly for electrical systems including renewable energy.
Lei Chen +3 more
doaj +1 more source
IEEE Access, 2018 To enhance the stability of a micro-grid under fault conditions, this paper proposes the coordination control of a superconducting magnetic energy storage (SMES), an active superconducting fault current limiter (SFCL), and distributed generation units ...
Lei Chen +8 more
doaj +1 more source
Above Room Temperature Ferroelectricity in Epitaxially Strained KTaO3
Advanced Materials, EarlyView.Through precise epitaxial engineering, the cubic and paraelectric KTaO3${\rm KTaO}_3$ is transformed into a robust ferroelectric. By leveraging lattice‐mismatched substrates to apply controlled epitaxial strain, a stable ferroelectric ground‐state is achieved with a transition temperature as high as 475 K, establishing KTaO3${\rm KTaO}_3$ as a highly ...
Tobias Schwaigert +11 more
wiley +1 more source
Advanced Materials Technologies, EarlyView.The article overviews past and current efforts on caloric materials and systems, highlighting the contributions of Ames National Laboratory to the field. Solid‐state caloric heat pumping is an innovative method that can be implemented in a wide range of cooling and heating applications.
Agata Czernuszewicz +5 more
wiley +1 more source
Enhancing LVRT Capability of DFIG-Based Wind Turbine Systems with SMES Series in the Rotor Side
International Journal of Rotating Machinery, 2017 The necessary Low Voltage Ride Through (LVRT) capability is very important to wind turbines. This paper presents a method to enhance LVRT capability of doubly fed induction generators- (DFIGs-) based wind turbine systems with series superconducting ...
Xiao Zhou, Yuejin Tang, Jing Shi
doaj +1 more source
Engineering Exciton g‐Factors With Light in Type‐II Heterostructures
Advanced Optical Materials, EarlyView.All‐optical approaches have emerged as cutting‐edge alternatives for ultrafast, energy‐efficient, and spatially localized tuning and switching of material properties. In our work, we demonstrate how light intensity alone can be leveraged to engineer g‐factors from a single‐type of carrier in type‐II heterostructures through Coulomb‐induced wavefunction
G. M. Jacobsen +9 more
wiley +1 more source