Results 171 to 180 of about 278 (222)

Comprehensive Review of RF MEMS Switches in Satellite Communications. [PDF]

Sensors (Basel)
Shao B, Lu C, Xiang Y, Li F, Song M.
europepmc   +1 more source

Engineering nanocolumnar defect configurations for optimized vortex pinning in high temperature superconducting nanocomposite wires. [PDF]

Sci Rep, 2013
Wee SH, Zuev YL, Cantoni C, Goyal A.
europepmc   +1 more source

Enhanced grid integration through advanced predictive control of a permanent magnet synchronous generator - Superconducting magnetic energy storage wind energy system.

Heliyon
Lv R, Ahmad Bhat R.
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Superconducting fault current limiter development

IEEE Transactions on Magnetics, 1991
The authors have developed and tested a 400-V 100-A-class fault current limiter wound with AC superconducting wire with ultrafine NbTi filaments. The limiter consists of noninductively wound superconducting trigger coils and a superconducting limiting coil which acts as a reactor.
D. Ito, K. Tsurunaga, E.S. Yoneda, Y. Sugiyama, T. Hara, K. Okaniwa, H. Hoshino, T. Yamamoto   +7 more
exaly   +2 more sources

A superconducting fault-current limiter

Journal of Applied Physics, 1978
A conceptual design is presented for a fault-current limiter for the electrical power utilities which utilizes a superconducting element to commutate the fault current into a shunt resistor. The technical feasibility of the concept is supported by a computer simulation of the switching.
K. E. Gray, D. E. Fowler
openaire   +1 more source

Superconducting fault current limiters

IEE Colloquium on High Tc Superconducting Materials as `Magnets', 1995
Fault current limiters (FCLs), superconducting or otherwise, have the potential to reduce fault levels on electricity power networks, and may ultimately lead to lower rated components (i.e. cheaper) being used, or to increased capacity on existing systems.
openaire   +2 more sources

A practical superconducting fault current limiter

IET Conference Publications, 2009
This paper discusses the increasing requirements for an effective means of controlling fault levels on electrical networks and describes the work by Rolls-Royce and partners to develop a practical superconducting fault current limiter. Practical superconducting fault current limiters require materials with a high tolerance to mechanical process ...
P. Hopewell, M. Husband, A. Smith
openaire   +1 more source

DC superconducting fault current limiter

Superconductor Science and Technology, 2006
There is a lack of satisfying solutions for fault currents using conventional technologies, especially in DC networks, where a superconducting fault current limiter could play a very important part. DC networks bring a lot of advantages when compared to traditional AC ones, in particular within the context of the liberalization of the electric market ...
Cointe, Yannick, Tixador, Pascal, Villard, C.   +2 more
openaire   +2 more sources

Non‐superconducting fault current limiters

European Transactions on Electrical Power, 2008
AbstractThis paper proposes the use of non‐superconducting DC reactor type fault current limiter (NSFCL) instead of superconducting fault current limiters (SFCLs) which has high cost and technology. Proposed FCL consists of three similar sets, each including a diode bridge and a single non‐superconducting DC reactor.
M. Tarafdar Hagh, M. Abapour
openaire   +1 more source

Towards the superconducting fault current limiter

IEEE Transactions on Power Delivery, 1991
The advent of low-loss AC superconductor wires opens the way to a new current limiting technique: that of extremely fast transition from a superconducting state to a resistive state when the fault current exceeds the conductor's critical current. A 25 kV single-phase prototype is described which consists of a Nb Ti superconducting coil without iron ...
E. Thuries, V.D. Pham, Y. Laumond, T. Verhaege, A. Fevrier, M. Collet, M. Bekhaled   +6 more
openaire   +1 more source