Results 151 to 160 of about 262 (205)
Engineering challenges for accelerated fusion demonstrators. [PDF]
Philos Trans A Math Phys Eng Sci, 2019 Surrey E.
europepmc +1 more source
Comprehensive Review of RF MEMS Switches in Satellite Communications. [PDF]
Sensors (Basel)Shao B, Lu C, Xiang Y, Li F, Song M.
europepmc +1 more source
Engineering nanocolumnar defect configurations for optimized vortex pinning in high temperature superconducting nanocomposite wires. [PDF]
Sci Rep, 2013 Wee SH, Zuev YL, Cantoni C, Goyal A.
europepmc +1 more source
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Superconducting fault current limiter development
IEEE Transactions on Magnetics, 1991The authors have developed and tested a 400-V 100-A-class fault current limiter wound with AC superconducting wire with ultrafine NbTi filaments. The limiter consists of noninductively wound superconducting trigger coils and a superconducting limiting coil which acts as a reactor.
D. Ito +7 more
exaly +2 more sources
A superconducting fault-current limiter
Journal of Applied Physics, 1978A conceptual design is presented for a fault-current limiter for the electrical power utilities which utilizes a superconducting element to commutate the fault current into a shunt resistor. The technical feasibility of the concept is supported by a computer simulation of the switching.
K. E. Gray, D. E. Fowler
openaire +1 more source
Superconducting fault current limiters
IEE Colloquium on High Tc Superconducting Materials as `Magnets', 1995Fault current limiters (FCLs), superconducting or otherwise, have the potential to reduce fault levels on electricity power networks, and may ultimately lead to lower rated components (i.e. cheaper) being used, or to increased capacity on existing systems.
openaire +2 more sources
A practical superconducting fault current limiter
IET Conference Publications, 2009This paper discusses the increasing requirements for an effective means of controlling fault levels on electrical networks and describes the work by Rolls-Royce and partners to develop a practical superconducting fault current limiter. Practical superconducting fault current limiters require materials with a high tolerance to mechanical process ...
P. Hopewell, M. Husband, A. Smith
openaire +1 more source
Towards the superconducting fault current limiter
IEEE Transactions on Power Delivery, 1991The advent of low-loss AC superconductor wires opens the way to a new current limiting technique: that of extremely fast transition from a superconducting state to a resistive state when the fault current exceeds the conductor's critical current. A 25 kV single-phase prototype is described which consists of a Nb Ti superconducting coil without iron ...
E. Thuries +6 more
openaire +1 more source