Results 61 to 70 of about 265 (212)

Phase Engineering of Nanomaterials (PEN): Evolution, Current Challenges, and Future Opportunities

Advanced Materials, EarlyView.
This review summarizes the synthesis, phase transition, advanced characterization spanning ex situ to in situ and operando techniques, and diverse applications of phase engineering of nanomaterials (PEN). It further outlines key challenges and future opportunities, such as phase stability, architecture control, and artificial intelligence (AI)‐driven ...
Ye Chen, Zhanxi Fan, Jingjie Ge, Qiyuan He, Zhuangchai Lai, Jiawei Liu, Chaoliang Tan, Hua Zhang   +7 more
wiley   +1 more source

Analisa Penggunaan Superconducting Fault Current Limiter (SFCL) Untuk Melindungi Peralatan di PT Pindo Deli

Jurnal Teknik ITS, 2015
Increas demand load and power capacity requirement at PT Pindo Deli then the short circuit current that occur will be greater. this can cause damage to electrical equipment located around the point of interrupting and resulting failure of the electrical ...
Yohanes Sabriant Widyo Utomo, Margo Pujiantara, Arif Musthofa   +1 more
doaj  

Development of a Voltage Compensation Type Active SFCL and Its Application for Transient Performance Enhancement of a PMSG-Based Wind Turbine System

Advances in Condensed Matter Physics, 2017
Considering the rapid development of high temperature superconducting (HTS) materials, superconducting power applications have attracted more and more attention in the power industry, particularly for electrical systems including renewable energy.
Lei Chen, Hongkun Chen, Jun Yang, Huiwen He   +3 more
doaj   +1 more source

Coordination of SMES, SFCL and Distributed Generation Units for Micro-Grid Stability Enhancement via Wireless Communications

IEEE Access, 2018
To enhance the stability of a micro-grid under fault conditions, this paper proposes the coordination control of a superconducting magnetic energy storage (SMES), an active superconducting fault current limiter (SFCL), and distributed generation units ...
Lei Chen, Hongkun Chen, Guocheng Li, Xin Tian, Ying Xu, Li Ren, Yanhong Li, Lin Zhu, Yuejin Tang   +8 more
doaj   +1 more source

Comparative Analysis of Work Function Measurement Techniques Based on Scanning Probe Microscopy

Advanced Materials, EarlyView.
Non‐contact scanning probe microscopy visualizes the surface topography based on surface electronic properties. The tunneling current, which defines the geometry of the tunnel–junction, has to overcome the effective surface work function barrier to reach the probe from the surface.
Daryoush Nosraty Alamdary, Matthias Bode, Artem Odobesko   +2 more
wiley   +1 more source

Influence of Shunt Branch on the Current Limiting and Recovery Performance of Variable Resistance SFCL

IEEE Access
With the continuous development of power grid, the high short-circuit threatens the stability of the power system. The short-circuit exceeds the disconnection capacity of the circuit breaker and has a negative impact on the integrity and stability of the
Duanjiao Li, Bin Xiang, Congwei Yao, Qi Zhang, Xiaofeng Pang, Wenxing Sun, Haiyun Tang, Xue Zhang, Zhongbin Yuan, Linglong Cai   +9 more
doaj   +1 more source

From the Discovery of the Giant Magnetocaloric Effect to the Development of High‐Power‐Density Systems

Advanced Materials Technologies, EarlyView.
The article overviews past and current efforts on caloric materials and systems, highlighting the contributions of Ames National Laboratory to the field. Solid‐state caloric heat pumping is an innovative method that can be implemented in a wide range of cooling and heating applications.
Agata Czernuszewicz, Yaroslav Mudryk, Jun Cui, Lucas Griffith, Duane D. Johnson, Julie Slaughter   +5 more
wiley   +1 more source

Enhancing LVRT Capability of DFIG-Based Wind Turbine Systems with SMES Series in the Rotor Side

International Journal of Rotating Machinery, 2017
The necessary Low Voltage Ride Through (LVRT) capability is very important to wind turbines. This paper presents a method to enhance LVRT capability of doubly fed induction generators- (DFIGs-) based wind turbine systems with series superconducting ...
Xiao Zhou, Yuejin Tang, Jing Shi
doaj   +1 more source

Sustainable Materials Design With Multi‐Modal Artificial Intelligence

Advanced Science, EarlyView.
Critical mineral scarcity, high embodied carbon, and persistent pollution from materials processing intensify the need for sustainable materials design. This review frames the problem as multi‐objective optimization under heterogeneous, high‐dimensional evidence and highlights multi‐modal AI as an enabling pathway.
Tianyi Xu, Tianshuo Wei, Yan Ge, Bo Peng, Yue Li, Maolin Wang, Peng Wen, Chao Yang, Ye Wei   +8 more
wiley   +1 more source

Behavior Of Superconducting Fault Current Limiter Under Fault Condition

, 2017
Now a days due to increase in electricity demand for the purpose of industrialization, agriculture, domestic and educational etc there exists more chances of fault occurance. The Faults occurs due to insulation damaging, breaking of conductor, short circuit, lightning etc.
KARUNA L. BARI, S. M. SHEMBEKAR
openaire   +3 more sources