Results 111 to 120 of about 8,178 (302)
Spontaneous Cyclic Levitation of Glycerol‐Water Droplets at Low Pressures
Advanced Science, EarlyView.Under low pressure, a minute glycerol addition transforms the chaotic dynamics of freezing water droplets into cyclic levitation. Freeze‐concentration preserves liquid pathways that relax expansion‐induced stress, while freezing point depression weakens asymmetric vaporization recoil.
Chen Xu +10 more
wiley +1 more source
, 2016 A methylsilicone/phenolic resin/silica composite surface was prepared by a casting method. The wetting behavior of the surface was investigated. It was found that the as-prepared surface can be varied from superhydrophilicity to superhydrophobicity as ...
Qihua Wang (1758721) +1 more
core +1 more source
Advanced Energy Materials, EarlyView.Surface‐engineering Ti3C2Tx MXenes with an in situ‐grown TiO2 layer on the surface in combination with visible‐light‐absorbing Cu2O significantly enhances charge separation and carrier extraction while improving Cu2O resistance to photocorrosion. The resulting Cu2O/TiO2‐MXene photocathodes enable highly selective, solar‐driven ethanol production ...
Luis A. M. Carrascosa +4 more
wiley +1 more source
Particle morphology dependent superhydrophobicity in treated diatomaceous earth/polystyrene coatings
, 2017 Superhydrophobic surfaces have been prepared from three different types of diatomaceous earth (DE) particles treated with 3-(heptafluoroisopropoxy)propyltrimethoxysilane (HFIP-TMS) and low molecular mass polystyrene.
Bhishma R. Sedai +10 more
core +1 more source
Membrane‐aided simultaneous reaction–separation for liquid phase products
AIChE Journal, EarlyView.Abstract Conventionally, reaction and separation are conducted as separate steps in liquid‐phase manufacturing, with products formed during reaction and subsequently separated from unreacted reagents, solvents, and byproducts. Integrating these steps into a simultaneous reaction–separation process can improve efficiency and reduce costs.
Yihan Song +4 more
wiley +1 more source
Electrospun fibrous membranes with super-large-strain electric superhydrophobicity
, 2015 Large-strain elastic superhydrophobicity is highly desirable for its enhanced use performance and functional reliability in mechanically dynamic environments, but remains challenging to develop.
H Niu (14449581) +3 more
core
Printed Wearable Sweat Rate Sensor for Continuous In Situ Perspiration Measurement
Advanced Intelligent Systems, Volume 7, Issue 3, March 2025.A wireless wearable sweat rate sensor system is presented, featuring digital 3D direct‐write printing on a flexible substrate with microfluidic layers for continuous, real‐time monitoring. Printed encapsulated metal electrodes are used for capacitance measurements, achieving high sensitivity (0.01 μL min−1) while maintaining a compact and lightweight ...
Mohammad Shafiqul Islam +6 more
wiley +1 more source
Fundamentals, Advances, and Applications of Electrospun Nanofibrous 3D Materials
Journal of Applied Polymer Science, EarlyView.Three‐dimensional electrospun nanofibrous systems offer unique properties and microenvironments. These properties are determined by the fabrication strategies employed and can be adjusted by the incorporation of functional additives to achieve multifunctionality for specific applications. The applications range from the biomedical to the environmental,
Rebecca Hengsbach +4 more
wiley +1 more source
, 2016 Hydrogen-Bonding-Driven Wettability Change of Colloidal Crystal Films: From Superhydrophobicity to ...
Jingxia Wang (692422) +4 more
core +1 more source
Carbon Energy, EarlyView.This review highlights polymer‐mediated interfacial engineering strategies for Cu‐based electrocatalysts toward enhanced CO2RR, including steering the electronic structure of Cu, enhancing CO2 adsorption and activation, regulating the reaction microenvironment, constructing a molecular protective layer, and stabilizing the key intermediate.
Haoquan Peng +7 more
wiley +1 more source