Results 51 to 60 of about 21,203 (255)
Structural Concrete, EarlyView.Abstract A total of four reinforced concrete (RC) columns were tested to compare the structural capacities of RC columns produced by natural perlite aggregates and conventional concrete. The structural performance of the RC columns made from natural perlite aggregates was compared to conventional RC columns regarding the same concrete strength levels ...
Sefa Atlı +6 more
wiley +1 more source
The development of mobile robot for air pollution data capture (POPOBOT) [PDF]
, 2011 In the Modern era, the environmental issues have given significant impact to the human live. The air pollution indoor and outdoor environment sometimes dangerous to the human health and it needs to be justified.
A. Rahman, Khairul Azlan
core
Repeated autogenous healing in strain-hardening cementitious composites by using superabsorbent polymers [PDF]
, 2016 info:eu-repo/semantics ...
De Belie, Nele, Snoeck, Didier
core +1 more source
High-Power Fiber Laser Cutting for 50-mm-Thick Cement-Based Materials [PDF]
, 2020 This experimental research highlights the applicability of laser cutting to cement-based materials using multimode fiber lasers. A 9 kW multimode fiber laser is used, and the experimental variables are the water-to-cement ratio, laser speed, and material
Lee, Dongkyoung +2 more
core +1 more source
Structural Concrete, EarlyView.Abstract Fiber addition is a common strategy to enhance concrete's durability, avoiding cracks and reducing penetration of harmful agents. In this research, a sustainable fiber‐like material obtained from mechanical recycling of dismantled wind‐turbine blades and made up of glass fiber‐reinforced polymer (GFRP) fibers and microfibers, balsa wood, and ...
Javier Manso‐Morato +4 more
wiley +1 more source
Bond behavior of self consolidating concrete [PDF]
, 2016 The new generation of innovative projects has led to the use of greater amounts of reinforcement and the development of concrete with specific characteristics. It is necessary to use a material that ensures the uniformity of the cross section, as well as
Aguado de Cea, Antonio +2 more
core +3 more sources
Dry mixes on the basis of reactive-powder concrete
Zaštita Materijala, 2022 This article presents the results of experimental studies of mortars based on dry mixes using reactive-powder concrete (RPC). This type of concrete can serve not only as the structural material in the construction of buildings and structures, but also as
Leonid Dvorkin, Vitalij Marchuk
doaj +1 more source
Structural Concrete, EarlyView.Abstract Fly ash foam composite concrete (FFC) is a sustainable, lightweight alternative to traditional concrete. However, accurately predicting its compressive strength (CS) through conventional laboratory methods is challenging due to its non‐linear behavior induced by the addition of foam content and fly ash. Also, the laboratory determination of CS
Atta Ullah +5 more
wiley +1 more source
The complex binder based on Portland cement andash-and-slag wastes from thermal power stations [PDF]
, 2019 Increase in the balance of boiler and furnace fuel of the energy sector of the Republic of Belarus the proportion of own energy resources (milling peat and wood chips) places priority on resolving the issues of utilization of ash-and-slag wastes and ...
Vysotskaya, Maryia
core
Performance of two‐to‐one non‐contact post‐installed lap splices
Structural Concrete, EarlyView.Abstract Post‐installed lap splices ensure the continuity of steel reinforcement in concrete‐to‐concrete connections by overlapping cast‐in (CI) reinforcing bars (rebars) with post‐installed (PI) rebars. Typically, the design of such splices follows provisions originally intended for CI lap splices, despite the differences in execution and bond ...
Jose I. Croppi +4 more
wiley +1 more source