Results 141 to 150 of about 5,049,215 (291)

A Depolarizing Leak in Sodium Bicarbonate Cotransporter NBCe1 Causes Brain Edema

open access: yesAnnals of Clinical and Translational Neurology, EarlyView.
ABSTRACT Objectives SLC4A4 encodes electrogenic sodium bicarbonate cotransporter NBCe1, prominently expressed in kidney and brain. Recessive loss‐of‐function variants in SLC4A4 cause proximal renal tubular acidosis, no brain edema. In the brain, NBCe1 is expressed by astrocytes, where it regulates pH and mediates astrocyte volume changes.
Quinty Bisseling   +16 more
wiley   +1 more source

Comparative Effectiveness and Safety of Inebilizumab Versus Rituximab in AQP4‐IgG‐Positive NMOSD

open access: yesAnnals of Clinical and Translational Neurology, EarlyView.
ABSTRACT Objective Rituximab (anti‐CD20, RTX) and inebilizumab (anti‐CD19, INE) represent B‐cell‐depleting therapies used for aquaporin‐4 antibody‐positive (AQP4‐IgG+) neuromyelitis optica spectrum disorder (NMOSD); however, direct comparative evidence remains limited.
Jie Lin   +11 more
wiley   +1 more source

Clinical Practice Guideline for Evaluation and Management of Peripheral Nervous System Manifestations in Sjögren's Disease

open access: yesArthritis Care &Research, EarlyView.
Objective Sjögren's disease is an autoimmune disorder that can impact multiple organ systems, including the peripheral nervous system (PNS). PNS manifestations, which can exist concurrently, include mononeuropathies, polyneuropathies, and autonomic nervous system neuropathies.
Anahita Deboo   +88 more
wiley   +1 more source

Pain and Patient‐Reported Physical Function Did Not Differ Between Body Composition Profiles in Patients with Hip Osteoarthritis

open access: yesArthritis Care &Research, Accepted Article.
Objective To explore whether higher body fat and lower lean mass are associated with greater pain and worse patient‐reported physical function in individuals with hip osteoarthritis (OA). A secondary aim was to examine whether pain and patient‐reported physical function differ according to four body composition profiles: high body fat, low lean mass ...
Alexandra Ryan   +10 more
wiley   +1 more source

Mechanochemical Synthesis and Characterization of Nanostructured ErB4 and NdB4 Rare‐Earth Tetraborides

open access: yesAdvanced Engineering Materials, Volume 27, Issue 6, March 2025.
ErB4 and NdB4 nanostructured powders are produced by mechanochemical synthesis. 5 h mechanical alloying and 4 M HCl acid leaching are used in the production. ErB4 and NdB4 powders exhibit maximum magnetization of 0.4726 emu g−1 accompanied with an antiferromagnetic‐to‐paramagnetic phase transition at about TN = 18 K and 0.132 emu g−1 with a maximum at ...
Burçak Boztemur   +5 more
wiley   +1 more source

Enhancing Corrosion Resistance and Mechanical Strength of 3D‐Printed Iron Polylactic Acid for Marine Applications via Laser Surface Texturing

open access: yesAdvanced Engineering Materials, EarlyView.
Laser surface texturing significantly improves the corrosion resistance and mechanical strength of 3D‐printed iron polylactic acid (Ir‐PLA) for marine applications. Optimal laser parameters reduce corrosion by 80% and enhance tensile strength by 25% and ductility by 15%.
Mohammad Rezayat   +6 more
wiley   +1 more source

Rapid Solar Photoinactivation of Influenza Virus and Phi6 in Colored Surface Water. [PDF]

open access: yesEnviron Sci Technol
Anderson CE   +6 more
europepmc   +1 more source

Thermoreflectance Detection of Point Defects Resulting from Focused Ion Beam Milling

open access: yesAdvanced Engineering Materials, EarlyView.
Focused ion beam (FIB) milling is a common tool for nanoscale material processing, however irradiation damage, redeposition, and contamination can occur. We use several characterization tools to show FIB‐induced effects beyond 1 mm from the milled area.
Thomas W. Pfeifer   +3 more
wiley   +1 more source

Experimental Evaluation of 100Cr6 Steel Microindented Surfaces Under Lubricated Nonconformal Point Contacts

open access: yesAdvanced Engineering Materials, EarlyView.
The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy