Results 11 to 20 of about 666,363 (220)
Surge arrester leakage current modeling based on pollution layer electrical conductivity estimation [PDF]
Scientific ReportsThe surface leakage current (LC) of metal oxide surge arresters (MOSA) is highly dependent on environmental conditions. This factor influences the modeling of MOSA leakage current as an alternative solution to laboratory tests.
Arian Hoseini Nejadiyan Kooshki +1 more
doaj +2 more sources
Energies, 2018 The voltage distribution along the non-linear resistance of metal oxide surges is of great importance for their proper operation, since the non-uniform potential distribution results in higher thermal stresses of the varistor discs near the high voltage ...
Christos A. Christodoulou +3 more
doaj +2 more sources
Energies, 2017 The appropriate circuit modeling of metal oxide gapless surge arresters is critical for insulation coordination studies. Metal oxide arresters present a dynamic behavior for fast front surges; namely, their residual voltage is dependent on the peak value,
Christos A. Christodoulou +4 more
doaj +2 more sources
The efficiency of gas-filled surge arresters in the environment contaminated by non-ionizing radiation of fusion reactors [PDF]
Nuclear Technology and Radiation Protection, 2022 The research presents an experiment with a model of an electronic generator for energy injection into the plasma of a fusion reactor. By recording a non-ionizing field in the vicinity of a fusion reactor, it was determined that this field has an
Aranđelović Nemanja M. +5 more
doaj +1 more source
Energies, 2023 In this paper, we propose a mitigation method for reducing lightning-induced insulator voltages based on the installation of low-voltage surge arresters aligned parallelly to the insulator.
André M. de Morais +2 more
doaj +1 more source
Degradation Processes in Shield-Centring Elements of Surge Arresters [PDF]
Archives of Metallurgy and Materials, 2023 This paper presents the results of testing samples of shield-centering elements from medium-voltage surge arresters. The elements were made of TSE glass textolite.
P. Papliński +5 more
doaj +1 more source
Archives of Metallurgy and Materials, 2023 The paper presents results of investigation of microstructure and micro-hardness for material of ZnO varistors applied to 110 kV surge arrester and surge arrester counter.
J. Wańkowicz +5 more
semanticscholar +1 more source
Electronics, 2022 The results presented in this article relate to the study of the impact of gamma radiation on the breakdown voltage of gas-filled surge arrester manufactured by CITEL, Littelfuse and EPCOS at an operating voltage of 230 V.
E. Živanović +2 more
semanticscholar +1 more source
Characteristics and possibilities of software tool for metal-oxide surge arresters selection [PDF]
Zbornik Radova: Elektrotehnički Institut "Nikola Tesla", 2012 This paper presents a procedure for the selection of metal-oxide surge arresters based on the instructions given in the Siemens and ABB catalogues, respecting their differences and the characteristics and possibilities of the software tool.
Đorđević Dragan +2 more
doaj +1 more source
The influence of gamma and X-radiation on pre-breakdown currents and resistance of commercial gas filled surge arresters [PDF]
Nuclear Technology and Radiation Protection, 2005 The aim of this paper is to examine the influence of gamma and X-radiation on relevant characteristics of commercial gas filled surge arresters in the d. c. regime.
Lončar Boris B. +3 more
doaj +1 more source