Results 171 to 180 of about 926,088 (241)

Active Inference and Functional Parametrisation: Differential Flatness and Smooth Random Realisation. [PDF]

Entropy (Basel)
Mounier H, Parr T, Friston K.
europepmc   +1 more source

Pain and Patient‐Reported Physical Function Did Not Differ Among Body Composition Profiles in Patients With Hip Osteoarthritis

Arthritis Care &Research, EarlyView.
Objective To explore whether higher body fat and lower lean mass are associated with greater pain and worse patient‐reported physical function in individuals with hip osteoarthritis (OA). A secondary aim was to examine whether pain and patient‐reported physical function differ according to four body composition profiles: high body fat, low lean mass ...
Alexandra Ryan, Boliang Wang, Fiona Dobson, Ben Kirk, Travis Haber, Kim L. Bennell, Shirley P. Yu, Kim Allison, Ricardo J. S. Costa, Gabrielle Knox, Michelle Hall   +10 more
wiley   +1 more source

Isotropic fluid structures and role of non-metricity on their dynamics governed by an electric charge: A theoretical study. [PDF]

PLoS One
Naseer T, Sharif M, Waqas M, Andrade J, Emara A.   +4 more
europepmc   +1 more source

Neighborhood Socioeconomic Status and Short‐Term Functional Outcomes in Systemic Lupus Erythematosus

Arthritis Care &Research, Accepted Article.
Objective Individuals with SLE can accumulate functional status (FS) impairment. We evaluated the association between neighborhood socioeconomic disadvantage, as measured by the area deprivation index (ADI), and FS in a national SLE sample. Methods Data were derived from RISE, a national electronic health record‐based registry.
Baljeet Rai, Jessica Fitzpatrick, Jing Li, Eric Roberts, Patricia Katz, Laura Plantinga, Gabriela Schmajuk, Jinoos Yazdany   +7 more
wiley   +1 more source

Optimization of asymmetric gyrostatic satellite kinematics in a resistive medium: A novel elliptic function solution. [PDF]

Sci Rep
Elneklawy AH, Amer TS, Elkilany SA, Seliem ASA, Hegazy N.   +4 more
europepmc   +1 more source

Revisiting Stability Criteria in Ball‐Milled High‐Entropy Alloys: Do Hume–Rothery and Thermodynamic Rules Equally Apply?

Advanced Engineering Materials, Volume 27, Issue 6, March 2025.
The stability criteria affecting the formation of high‐entropy alloys, particularly focusing in supersaturated solid solutions produced by mechanical alloying, are analyzed. Criteria based on Hume–Rothery rules are distinguished from those derived from thermodynamic relations. The formers are generally applicable to mechanically alloyed samples.
Javier S. Blázquez, Alejandro F. Manchón‐Gordón, Antonio Vidal‐Crespo, Rafael Caballero‐Flores, Jhon J. Ipus, Clara F. Conde   +5 more
wiley   +1 more source

Notes on the Jellinek-Berry Thermostated Ideal Gas. [PDF]

J Stat Phys
Butler LT, Sharifi A.
europepmc   +1 more source

Experimental Evaluation of 100Cr6 Steel Microindented Surfaces Under Lubricated Nonconformal Point Contacts

Advanced Engineering Materials, EarlyView.
The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi, Pasquale Guglielmi, Gianfranco Palumbo, Giuseppe Carbone   +3 more
wiley   +1 more source

Cyclization in random graph modeling of acrylate copolymerization.

Soft Matter
van 't Hoff T, Schilperoort T, Kryven IV, Iedema PD.   +3 more
europepmc   +1 more source

Analysis of delay differential equations with dual caputo-type fractional derivatives using laplace transform methods. [PDF]

Sci Rep
Boumaaza M, Boutiara A, Djidel O, Guefaifia R, Boulaaras S.   +4 more
europepmc   +1 more source