Improving activation cross section data with TALYS [PDF]
Needs for accurate (n,x) activation cross sections for fusion technology have been considered with reference to the current status of the TENDL library. The current work is focused on improving activation cross section data for nuclear reactions relevant
Dzysiuk Nataliia, Koning Arjan
doaj +4 more sources
0-8 MeV Enerji Bölgesinde 13C(α,n)16O Reaksiyonu için Astrofiziksel S-Faktörlerin Hesaplanması [PDF]
> Değerlendirilmek üzere makalenizi göndermeden önce "Dergi Hakkında", "Yayın İlkeleri" ve "Yazar Rehberi" sayfalarını inceleyerek gerekli düzenlemeleri yaptığınıza emin olunuz.> Çalışmanızı dergi yazım kurallarına uygun olarak hazırlayınız.> Bu
Ercan YILDIZ
doaj +2 more sources
The (α,n) reaction cross-section calculations for some isotopes of iron group elements in the range of 5-20 MeV [PDF]
Iron group elements (Sc, Mn, Fe, Co, Ni) are especially very important because structural material selection in design of fusion–fission reactors is very crucial.
Yildiz Ercan
doaj +2 more sources
Double differential light charged particle emission cross sections for some structural fusion materials [PDF]
In fusion reactors, neutron induced radioactivity strongly depends on the irradiated material. So, a proper selection of structural materials will have been limited the radioactive inventory in a fusion reactor.
Sarpün Ismail Hakki +2 more
doaj +2 more sources
New evaluations of n + Cu and n + Zr cross-section data for neutron energies up to 200 MeV [PDF]
This work presents evaluated general purpose nuclear data files for the n+ 63,65Cu and n+ 90,91,92,94,96Zr reactions for neutron energies up to 200 MeV.
Pereslavtsev P. +3 more
doaj +2 more sources
Neutron inelastic cross section measurements for natTi [PDF]
A neutron inelastic scattering experiment was performed at the GELINA (Geel Electron LINear Accelerator) neutron source of the European Commission Joint Research Centre Geel (EC-JRC Geel) with the aim of determining the reaction cross sections for the ...
Olacel Adina +10 more
doaj +2 more sources
Investigation of 54Fe(, n)57Ni Reaction for Low Activation Material Fe [PDF]
In fusion reactors, radioactivity can be controlled by effective material selection. Material selection is always important for effi cient conversion of radioactivity to electrical energy.The selection of structural materials provides more effi cient use
Ercan Yildız
core +1 more source
Obtaining Astrophysical S-Factors and Half-Experimental Cross-Section Values for 121Sb (α, n) 124I Reaction [PDF]
In this study, 121Sb (α, n) 124I reaction, which is one of the production reactions of the 124I radioisotope, which has an important use in nuclear medicine, was investigated.
Ercan Yıldız
core +1 more source
Measurement of 92Mo(n,α)89Zr and 97Mo(n,p)97Nb reactions at the neutron energy 13.52 MeV with covariance analysis [PDF]
The cross sections have been estimated for the Nuclear reactions 92Mo(n,α)89Zr and 97Mo(n,p)97Nb produced in Purnima neutron generator at neutron energy of 13.52±0.0045 MeV using activation analysis and off-line γ -ray spectrometric techniques.
Pasha, Imran ; Department of Physics, Bangalore University, Bengaluru 560 056, India +8 more
core +2 more sources
Excitation functions of proton-induced reactions on [PDF]
Excitation functions of proton-induced reactions for the natural iron and zirconium targets were measured from their respective threshold energies to 22 and 20 MeV. The conventional stacked foil technique was used in combination with the off-line $\gamma$
S. V. Suryanarayana +6 more
core +1 more source

