Results 101 to 110 of about 9,892 (253)
Solid polymer electrolyte films of PVdF‐HFP/PVAc blend with LiCF3SO3 were prepared by solution casting. XRD, FESEM, and FTIR confirmed reduced crystallinity and enhanced amorphous nature. Ionic conductivity reached 3.46 × 10−4 S cm−1 for optimized SP4.
B. Praveen Kumar +2 more
wiley +1 more source
Review and prospects of shear test of bolted rock joints
The laboratory shear test equipment, test method, and numerical simulation of bolted rock joints were summarized. The shortcomings and limitations of the current research were analyzed, and the research prospects were proposed. Abstract Rock bolting is a critical approach in geotechnical engineering for supporting weak rocks.
Shulin Ren +4 more
wiley +1 more source
A novel cavity contraction solution and multilayer shaft wall model were developed to analyze deep shaft stability, considering rock viscosity, support structures, and water pressure, with successful validation through a Hulusu Coal Mine case study.
Bin Chen +5 more
wiley +1 more source
Joint orientation significantly affects P‐wave velocity, with the highest velocity at zero‐degree angles, decreasing to 30° as the angle increases. The velocity increases slightly from 30 to 45 degrees but sharply decreases from 45 to 90 degrees. Abstract Determination of the required parameters in different science contexts using the ultrasonic wave ...
Yaghoob Zarei +4 more
wiley +1 more source
Seismic waves with tensile stress, high amplitude, and low frequency are most likely to trigger block instability and sliding. Blocks with a single sliding surface are more prone to movement than those with multiple constraints, and roof‐positioned blocks are especially vulnerable to slide.
Xiao Wang +4 more
wiley +1 more source
This study examines the effects of curing temperature on the mechanical behavior of underground rock masses treated with enzyme‐induced calcite precipitation (EICP) and an innovative biopolymer‐modified EICP (BP‐EICP). Abstract Biocementation is an innovative and sustainable technique for reinforcing weak and weathered rock masses in natural and ...
Mary C. Ngoma, Oladoyin Kolawole
wiley +1 more source
This review elucidates the velocity–dispersion–attenuation coupling mechanisms of wave propagation in rock masses, compares six representative models, and reveals how pressure, temperature, mineral composition, and anisotropy jointly control dynamic responses in complex geological media.
Jiajun Shu +8 more
wiley +1 more source
Seismic analysis and design of tunnels within fault ground: A review
The research methods of seismic response of tunnels within fault ground, including field investigations, analytical solutions, physical experiments, and numerical simulations, and seismic countermeasures are discussed. The present study examines the shortcomings and limitations of the current research and design, and puts forward proposals for future ...
Xingda Wang +6 more
wiley +1 more source
Dynamic response at the terminus of oblique intersecting joints subjected to stress waves
This study derives the propagation equation for stress waves impinging upon nonlinear oblique intersecting joints. It analyzes the dynamic response at the terminus of nonlinear oblique intersecting joints subjected to stress waves. Abstract To investigate the dynamic response at the terminus of oblique intersecting joints subjected to stress waves, a ...
Gang Hu +4 more
wiley +1 more source
The tensile strength of granite, a proposed host for nuclear waste, degrades severely above 400°C. We link this to specific microcracking patterns captured by acoustic emission, establishing a scientific basis for assessing repository safety under thermal load.
Wei Zeng +7 more
wiley +1 more source

