Results 41 to 50 of about 20,297 (303)
Targets’ Radial and Tangential Velocities Estimation Based on Vortex Electromagnetic Waves
The orbital angular momentum (OAM) of a vortex electromagnetic wave (VEW) has gained attention as a newly explored information carrier. OAM modes provide vortex azimuth resolution, which is a new degree of freedom (DOF) in radar application. Due to the special characteristics of the vortex azimuth domain, VEW shares compound Doppler information of two ...
Caipin Li +7 more
openaire +2 more sources
Analysis of External Magnetized Dissipative Thermo-convective Tangent Hyperbolic-micropolar Flow on a Rotating Non-isothermal Cone with Hall Current and Joule Dissipation: Electro-conductive Polymer Spin Coating [PDF]
Motivated by spin coating operations for magnetic polymers, a theoretical and numerical study is conducted of nonlinear, steady-state boundary layer flow and heat transfer of an incompressible tangent hyperbolic non-Newtonian micropolar fluid from a ...
S. Abdul Gaffar +4 more
doaj +1 more source
This paper describes a practical wheel/rail tangential contact force model for railway dynamics analysis under running in rainy conditions. In our previous studies, it was confirmed that experimental results of tangential contact force measurement are ...
Daisuke YAMAMOTO
doaj +1 more source
The Upper Swirling Liquid Film (USLF) phenomenon that occurs in the upper cylinder of the Gas–Liquid Cylindrical Cyclone (GLCC) separator is the direct cause of the low separation efficiency of the liquid phase.
Ti Yue +9 more
doaj +1 more source
ABSTRACT Objective Considerable efforts have been dedicated to developing effective treatments for post‐stroke executive impairment (PSEI), among which repetitive transcranial magnetic stimulation (rTMS) has shown great potential. This study aimed to investigate the therapeutic effects of high‐frequency rTMS on working memory (WM) and response ...
Mengting Lao +6 more
wiley +1 more source
Evaluating Energy Absorption Performance of Filled Lattice Structures
Maximum stress must be considered to robustly evaluate energy absorber designs. This approach was applied to compare all types of absorbers in a single Ashby diagram and determine the utility of filling lattice voids with a second material. High‐performance fillers can improve the performance of lattices that are limited by buckling or catastrophic ...
Christian Bonney +2 more
wiley +1 more source
A theoretical and numerical study is conducted on nonlinear, steady-state thermal convection boundary layer flow of a magnetized incompressible Tangent Hyperbolic non-Newtonian fluid from a rotating cone to a non-Darcy porous medium.
S. Abdul Gaffar +3 more
doaj +1 more source
Performance Analysis of Abradable Coating Systems for Aircraft Gas Turbines
Three CoNiCrAlY/YSZ/MgAl2O4 abradable liner configurations on a nickel‐superalloy are evaluated by thermal‐gradient cycling and incursion tests. Laser ablation of the bondcoat and/or Y2O3‐stabilized ZrO2 (YSZ) intermediate layer increases mechanical interlocking and bonding for thick topcoats.
Hanna Heyl +4 more
wiley +1 more source
Heat transfer in a confined impinging jet with swirling velocity component
Heat transfer measurements based on an infrared experimental method (TOIRT) are compared with CFD simulations of a confined impinging jet with tangential velocity component.
Petera Karel, Dostál Martin
doaj +1 more source
Falling film evaporation technology is widely used in the treatment of salt-containing wastewater in coal chemical industry. However, there is still a lack of research on the inlet method of vertical falling film evaporation tubes.
Xiang Cheng Kong +7 more
doaj +1 more source

