Results 21 to 30 of about 20,524 (255)
Kuangchan zonghe liyong, 2022 This article was aimed at a certain tellurium-bearing gold ore and its samples after alkaline leaching. Through the process mineralogical analysis of two samples, the elemental composition, mineral composition and minerals of the ore in the sampleswere ...
Chao Xu +5 more
doaj +1 more source
Crystals, 2022 Solar energy applications rely heavily on p-block elements and transition metals. Silicon is, by far, the most commonly used material in photovoltaic cells and accounts for about 85% of modules sold presently.
Prabhat Kumar Tripathy, Kunal Mondal
doaj +1 more source
Metals, 2020 The rigorous environmental requirements promote the development of new processes with short and clean technical routes for recycling tellurium from tellurium-bearing sodium carbonate slag.
Zhipeng Xu +6 more
doaj +1 more source
Effect of tellurium on the nucleation process of spheroidal graphite in cast iron
Journal of Materials Research and Technology, 2022 The crystallization of graphite nodules in cast iron is initiated by compounds acting as heterogeneous nuclei. Sulfur promotes precipitation of such non-metallic substrates, increasing the nodule count. It is reasonable to assume that homologous elements
Gorka Alonso +4 more
doaj +1 more source
Mineralogy and geochemistry of tellurium in the some mining sites of Transbaikalia [PDF]
E3S Web of Conferences, 2023 The first results of the study of the occurrence and mineral forms of tellurium in hypogenic and hypergenic conditions on the example of some deposits in Transbaikalia are presented in the article.
Eremin O. V., Yurgenson G. A.
doaj +1 more source
Thermoelectric PANI/TeNWs Fiber Based Microsensor for Passive Temperature and Active Chemical Sensing. [PDF]
Adv Sci (Weinh)Continuous wet‐spinning of PANI with TeNWs yields a multifunctional microfiber. Oriented TeNWs impose chain alignment and enhance π‐electron delocalization, boosting the Seebeck coefficient to 59.9 µV K−1 for passive temperature sensing (1 K detection limit), while achieving high pH sensitivity (59.25 mV pH−1) and rapid NH3 response (0.96 s).
Xie D +10 more
europepmc +2 more sources
Tellurium Behavior in the Containment Sump: Dissolution, Redox, and Radiolysis Effects [PDF]
, 2020 In the event of a severe nuclear accident, one major concern is the release of radioactive material into the environment causing potential exposure of the general public to radiation.
Foreman, Mark +7 more
core +1 more source
Pressure dependence of raman modes in double wall carbon nanotubes filled with 1D tellurium [PDF]
, 2010 The preparation of highly anisotropic one-dimensional (1D) structures confined into carbon nanotubes (CNTs) in general is a key objective in nanoscience.
Broto, Jean-Marc +11 more
core +1 more source
Tellurium nanosheets with structural anisotropy formed from defective MoTe2 multilayers
AIP Advances, 2023 We report on the formation of a tellurium nanosheet with a MoOx cap by thermal annealing of ion-implanted 2H–MoTe2 multilayers. The presence of crystal defects generated by ion implantation at an energy of 90 keV accelerates the incorporation of O atoms ...
Shuto Muranaka +4 more
doaj +1 more source
Fabrication of Te Micro-Tubes and TeO2 Micro-Wires From Powders by Cold Spray [PDF]
Engineering and Technology Journal, 2012 A one-dimensional micro-structured tellurium (Te) microtube and tellurium dioxide (TeO2) microwire were successfully prepared by cold spray process in large scale by a facile approach of sprayed (Te), (TeO2) dry powder in an inert atmosphere using helium
Mohammed S. Hamza +2 more
doaj +1 more source