Results 61 to 70 of about 439,037 (364)
ANALISIS PENGARUH PERLAKUAN PANAS TERHADAP PELAT KLASIFIKASI BKI TEBAL 10 mm PADA SAMBUNGAN LAS
Kapal, 2012 Heating treatment at the fabrication make the tensile strength, bending strength, and hardness strength are become lower. The research vision are to prover that heating at the plate without heating treatment, heating treatment 300 0C, heating treatment ...
Imam Pujo Mulyatno, Hartono Yudo
doaj +1 more source
Identification of inelastic parameters of the 304 stainless steel using multi-objective techniques [PDF]
, 2017 This work addresses identification of inelastic parameters based on an optimization method using a multi-objective technique. The problem consists in determining the best set of parameters which approximate three different tensile tests.
Tomiyama, M., Vaz Jr, M.
core
Advanced Engineering Materials, EarlyView.Microstructural evolution and hardness optimization along the cross‐section of friction stir welded AA6061/AlSi10MgMn joints, for electric vehicle battery housings, were investigated. Postweld aging between 170°C and 220°C enhances hardness uniformity within the nugget zone.
Emanuele Ghio, Emanuela Cerri
wiley +1 more source
Advanced Engineering Materials, EarlyView.In this experimental study, the mechanical properties of additively manufactured Ti‐6Al‐4V lattice structures of different geometries are characterized using compression, four point bending and fatigue testing. While TPMS designs show superior fatigue resistance, SplitP and Honeycomb lattice structures combine high stiffness and strength. The resulting
Klaus Burkart +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study investigates laser metal deposition of aluminum alloys EN AW‐7075 and EN AW‐5083, using powder blending to compensate zinc and magnesium evaporation. In situ alloying and ex situ alloying with ZnAl12 and AZ91 preserve near‐standard compositions and improve mechanical properties.
Finn Bendixen +3 more
wiley +1 more source
Comparative Study on the Test Method for Tensile Elastic Modulus of Rock Materials
Advances in Civil Engineering, 2019 Rock material has different mechanical behaviors under compressive and tensile loading. Correspondingly, there are two types of elastic modulus: compressive elastic modulus Ec and tensile elastic modulus Et, respectively.
Yan Zhang, Dawei Yu
doaj +1 more source
Advanced Engineering Materials, EarlyView.A novel, temperature‐controlled post‐consolidation unit is developed to test its potential to improve the melt impregnation process used to manufacture continuous fiber‐reinforced filaments for additive manufacturing of high‐performance thermoplastics.
Daniel Beermann +2 more
wiley +1 more source
Scientific ReportsThis study represents a novel contribution regarding the behavior of fiber-metal laminates (FMLs) under tensile impact loading. The experimental program included axial tensile-impact tests and quasi-static tensile and flexural tests after impact.
Islam El-Sagheer +2 more
doaj +1 more source
Effect of NaCl on texture modification of cuttlefish mantle (Sepia brevimana) [PDF]
Songklanakarin Journal of Science and Technology (SJST), 2008 The mechanical properties of cleaned cuttlefish mantle (Sepia brevimana) before and after spinning in cold salt solution were characterized by tensile and shear test.
Chakree Tongraung +2 more
doaj