Results 81 to 90 of about 8,778 (205)
Abstract Purpose To compare three posterolateral corner (PLC) reconstruction techniques—the popliteofibular loop (PFLoop), the modified LaPrade (LP) and modified Arciero (AR) techniques—in restoring knee laxity in varus (VR), external tibial rotation (ER) and posterior tibial translation (PTT). Methods Nine cadaveric knees were subjected to 8Nm VR, 5Nm
Marcos Barbieri Mestriner +5 more
wiley +1 more source
A Simple, Inexpensive Spinning-Drop Interfacial Tensiometer [PDF]
A spinning-drop interfacial tensiometer was designed, built, and tested. The device is very simple, inexpensive to build, and easy to operate compared with other spinningdrop tensiometers. The tensiometer measures the interfacial tension of liquid-liquid
Al-Rabiah, Humoud S.
core
Development of a Commercial Tensiometer for Triaxial Testing of Unsaturated Soils
A new suction probe, the WF-DU tensiometer, has been developed by Wykeham Farrance in collaboration with Durham University. The performance of the new suction probe is assessed in terms of the minimum negative value of pressure that can be measured by ...
Lourenco, Sergio +12 more
core +1 more source
Turfgrass irrigation: By Tensiometer-Controlled System
Tensiometers can be used successfully to determine frequency and duration of turfgrass irrigations, according to the trials reported here on three established golf greens.
W Morgan, A Marsh
doaj
Abstract Purpose The objective was to measure effects of joint line obliquity (JLO) on meniscus posterior root tension, tibiofemoral subluxation and contact pressures. It was hypothesised that a medial JLO would increase medial meniscal (MM) root tension, medial tibiofemoral subluxation and medial compartment contact pressure, and vice versa for ...
Shuntaro Nejima +5 more
wiley +1 more source
The Airplane Tensiometer [PDF]
Certain parts of an airplane are subjected not only to the stresses imposed by the aerodynamic or flying load, but also to the initial stresses, caused by the tension in the stay and drift wires. Report describes a tensiometer that measures such stresses
Larson, L J
core
Determining the intensity of the water balance components in the control volume of a soil, and consequently defining the most likely periods of occurrence of a water deficit in a crop, is an exercise that requires knowledge about soil, climate and plant ...
Monica Martins da Silva +2 more
doaj +1 more source
It is reported the design of biobased sustainable, smart, and functional adhesives achieved dispersing recycled carbon fibers into biobased epoxy monomer. ABSTRACT The development of sustainable, smart, and functional adhesives is crucial in advancing environmentally friendly materials.
Alberto Cellai +6 more
wiley +1 more source
The objective of the presented study was to develop a single probe that can be used to determine soil water retention curves in both laboratory and field conditions, by including a coiled time domain reflectometry (TDR) probe around the porous cup of a ...
Carlos M. P. Vaz +9 more
core +1 more source
Biosurfactant was produced by Pseudomonas aeruginosa using andiroba waste from Amazonia. A biosurfactant–alginate composite (Alg/BioS) was successfully synthesized via ionotropic gelation, and achieved up to 70% Cr6+ removal from water. Abstract Environmental contamination by heavy metals represents a significant challenge due to their persistence in ...
Paulo Diniz Austriaco +11 more
wiley +1 more source

