Results 71 to 80 of about 2,413,234 (210)
The purpose of this system is to simulate an internal short on battery cells by causing deformation (a crushing force) in a cell without penetration. This is performed by activating a hydraulic cylinder on one side of a blast wall with a hydraulic pump ...
Collins, Jacob +2 more
core +1 more source
Emissions data by category of engines [PDF]
, 1976 Exhaust gas pollutant emissions data under test stand conditions were obtained for the following: (1) full-rich baseline test (7-mode cycle), (2) lean-out tests for each power mode, and (3) different spark settings. The test data were also used to create
Barriage, J. +2 more
core +1 more source
A project within SwampWorks is building a test stand to hold regolith to study how dust is ejected when exposed to the hot exhaust plume of a rocket engine.
Pike, Cody J.
core +1 more source
The Rocketdyne Multifunction Tester. Part 1: Test Method [PDF]
, 1991 The Rocketdyne Multifunction Tester is a general purpose test apparatus which utilizes axial and radial magnetic bearings as shaft excitation devices. The tester is modular in design so that different seal and bearing packages can be tested on the same ...
Murphy, Brian T. +2 more
core +1 more source
Tests of electron gun at test stand completed
, 2022 This report describes the test stands constructed at CERN and the IAP at Goethe University Frankfurt with its different configurations and unique diagnostics as well as the first performance tests of the IRME-gun that has been developed within the scope of ARIES.
openaire +1 more source
Development of test stand for experimental investigation of chemical and physical phenomena in Liquid Rocket Engine [PDF]
Journal of Aerospace Technology and Management, 2011 The main objective of this work was to present the specification of an experimental firing test stand for liquid rocket engines (LRE) and develop a program for control and acquisition of data.
Emerson Andrade Santos +3 more
doaj
Against the Stand-Alone-Cost Test in U.S. Freight Rail Regulation [PDF]
The stand-alone-cost test has become an expensive, extensive, and time-consuming part of the regulatory practice of the U.S. Surface Transportation Board in the performance of its statutory duty to protect "captive shippers" from monopoly rail rates ...
Russell Pittman
core
Secondary Electron Yield Measurements of Fermilab's Main Injector Vacuum Vessel
, 2013 We discuss the progress made on a new installation in Fermilab's Main Injector that will help investigate the electron cloud phenomenon by making direct measurements of the secondary electron yield (SEY) of samples irradiated in the accelerator.
/Fermilab +14 more
core +2 more sources
SLS Test Stand Site Selection [PDF]
Test site selection is a critical element of the design, development and production of a new system. With the advent of the new Space Launch System (SLS), the National Aeronautics and Space Administration (NASA) had a number of test site selection ...
Crowe, Kathryn, Williams, Michael
core +1 more source