Results 81 to 90 of about 2,413,234 (210)
Measurement by a cylinder test stand and tyre rolling resistance [PDF]
Transport, 2006 Sometimes it is necessary to test how repair affects the properties of the car. These tests are carried out using a cylinder test stand. During the test the tyre is rolling between two cylinders of a small diameter.
A. Dávid, P. Faith, V. Rievaj
doaj
Hybrid propulsion systems for motor vehicles with predominantly intermittent modes of operation [PDF]
A small delivery vehicle was equipped with a flywheel-hybrid drive and compared in test stand and driving tests with a conventional drive vehicle.
Bartsch, H., Helling, J., Schreck, H.
core +1 more source
Cold Bead Pull Test Stand for SRF Cavities [PDF]
, 2016 Bead pull measurements represent a final step in the fabrication process of an SRF cavity. These tests allow to characterise the flatness of the field profile in order to mechanically tune the cavity to achieve design specifications. The realization of a
Frahm, A. +3 more
core +1 more source
Analytical study of the effects of wind tunnel turbulence on turbofan rotor noise [PDF]
The influence of tunnel turbulence on turbofan rotor noise was carried out to evaluate the effectiveness of the NASA Ames 40 by 80 foot tunnel in simulating flight levels of fan noise.
Gliebe, P. R., Kerschen, E. J.
core +1 more source
Design of cooling plate for vibration test stand [PDF]
, 2015 Tato práce se zabývá teplotní analýzou desky pro vibrační testovací zařízení na testování turbodmychadel. V úvodu je čtenář seznámen s principem přeplňování, jeho důležitostí a historií.
Drtílek, Juraj
core
Thermal Storage Advanced Thruster System (TSATS) Experimental Program [PDF]
The Thermal Storage Advanced Thruster System (TSATS) rocket test stand is completely assembled and operational. The first trial experimental runs of a low-energy TSATS prototype rocket was made using the test stand.
Lisano, Michael E., II, Rose, M. Frank
core +1 more source
The design and analysis of single flank transmission error tester for loaded gears [PDF]
To strengthen the understanding of gear transmission error and to verify mathematical models which predict them, a test stand that will measure the transmission error of gear pairs under design loads has been investigated.
Bassett, Duane E., Houser, Donald R.
core +1 more source
Refuge alternatives relief valve testing and design with updated test stand. [PDF]
Min Eng, 2018 Lutz TJ +3 more
europepmc +1 more source
Test stand performance of a convertible engine for advanced V/STOL and rotorcraft propulsion [PDF]
A variable inlet guide vane (VIGV) convertible engine that could be used to power future high-speed V/STOL and rotorcraft was tested on an outdoor stand.
Mcardle, Jack G.
core +1 more source